Plastic piece holding opening fan door at top broke in the middle of the night! Small black pieces...
(More)
Plastic piece holding opening fan door at top broke in the middle of the night! Small black pieces on floor;springs,screws,etc.;also the door1How to fiX? 2 years old almost to the day!
We have a GE Profile spacemaker 2.0 and lately it has started cutting off after around 4 minutes. It...
(More)
We have a GE Profile spacemaker 2.0 and lately it has started cutting off after around 4 minutes. It lasts longer on defrost as aposed to cook. After it cuts off the whole screen goes off and doesn't come back on for around 25 min and displays a power failure message when it comes back on. Please help
The GE profile Spacemaker that we have started acting up lately. While still in use its erratic. The...
(More)
The GE profile Spacemaker that we have started acting up lately. While still in use its erratic. The microwave does work but only when the vent is turned on with the button on the spacemaker. If it is turned on with out the vent it freezes. I can restart the spacemaker only by unplugging and replugging. Any suggestions how I can fix this. I would like to have the spacemaker work like before without the vent turned on. Dont like the Noise it makes. :) Thanks in advance.
GE Profile Spacemaker 2.0 - black buttons on panel for vent, boost, and light broke . Any way to...
(More)
GE Profile Spacemaker 2.0 - black buttons on panel for vent, boost, and light broke . Any way to replace the buttons and take the panel off?
The microwave could be in "Demo Mode" - Check your owners manual. In Whirlpool/Kenmore models this is indicated by a lower case...
written by ptishkevich
If the microwave operates normally, but does not heath at all, then it can be the high voltage capacitor,
the rectifier diode.or the magnetron.
The...
written by ginko
I have included a schematic of the interior of the built in Monogram Advantium Microwave oven Model KSC1001. The interior halogen light burned out and...
written by johnc01
A microwave not heating up is caused by one or more of the following -
1) Failed controller board (unlikely if you are getting a clock readout
and...
written by MrMark52
Problem: Totally dead oven.
Possible causes:
No power to outlet (blown fuse or tripped breaker or GFCI).
Blown main fuse - likely due...
written by sweet_rascal
The folks at GE told me you need a technician to change this bulb. Phooey, I say. It was a piece of cake. Save $ 100 and follow my instructions. I...
written by UNCLEMOE
I was also told that I would have to pay a technician to come out to replace the interior light bulb in my Advantium speedcook microwave, but after...
written by kersti
What can go wrong
The most common problems occur in the microwave generating portion of the
system, though the controller can be blown by a...
written by sweet_rascal
Splatters of food from microwaving look bad, smell bad, and decrease the efficiency of your microwave. Fortunately, microwaves aren't hard to clean if...
by wikihow