KitchenAid K5SS Heavy Duty Commercial Stand Mixer "opened screw side mixer" Questions

...screw and the name plate and then you'll see four screws (two on each side) holding on the top cover for the mixer. Remove the four screws and then lift off the top cover and you'll see the motor, ...

screw to the top and bottom side, levering the halves apart step by step. Do not use too much force! I'm stuck at the back of the case where the rubber ring is. I can't get this part open., but it's a

...mixer on, the two beaters hit each other, like they're a little out of sync. They are not bent. It's like one needs to be turned or reset in it's gear. Also, I do not know how ...

...screw. Remove this, and set it aside with the band which should come right off at this point. Now, there should be two screws on each side of the unit where the band used to be. Remove each of these. ...

...mixer will not turn back on after using it Make sure it's unplugged, remove and inspect the carbon brushes one at a time under those black screws on the side. They are keyed with one corner of the ...

mixer turned off and wont come on again Make sure it's unplugged, remove and inspect the carbon brushes one at a time under those black screws on the side. They are keyed with one corner of the square

...mixer to scrape the sides and now it will not come back on Make sure it's unplugged, remove and inspect the carbon brushes one at a time under those black screws on the side. They are keyed with one ...

...screw and turn it counter clock wise a quarter turn and start the mixer if it starts even for a half a second then the problem is in the switch. and your only problem is the proper timing set by the ...

...side of the planetary towards the column. The is a set screw. It should actually be a set screw on top of a set screw. Remove the first set screw. Back out the second screw one to two turns. Run the ...

screw will be seen if you lay the machine on its side and look up the shaft (pedestal) of the base (large empty area the head attaches to). You will see a small screw head (first item up the open part