Sharp R-420DK Microwave Oven "magnetron located carousel" Questions

...located the noise filter. there is a fuse on this board. check it for continuity with a ohm meter. if the fuse is ok, replace the Magnetron. There is also a diode in the same area. you can test this ...

...located on the right side in the air duct attached to the magnetron or on the top of the oven cavity. Most bulbs can be matched up at hardware stores, home improvement centers, and places like ...

...located on the floor of the chassis behind the control panel or between the door switches. If the fuse is good, it may be an open thermostat or thermal cutout (TCO) / thermal fuse on or near the ...

...located? Thanks. If the oven has not run for a few minutes and is not plugged in, there is very little chance that the high voltage capacitor has any charge stored on it.If you're still concerned ...

...magnetron replacement cost will depend upon the MODEL NUMBER and generally costs around $100. 4. Some model microwave ovens have a thermal cut-out (TCO) associated with the magentron circuit, and/or ...

...magnetron replacement cost will depend upon the model number, but generally costs around $100. 4. Some model microwave ovens have a thermal cut-out (TCO) associated with the magentron circuit, and/or ...

...magnetron may be closer to $200. 4. Some model microwave ovens have a thermal cut-out (TCO) associated with the magentron circuit, and/or oven cavity. If these small thermostats trip, they usually ...

...magnetron replacement cost will depend upon the MODEL NUMBER and generally costs around $100. 4. Some model microwave ovens have a thermal cut-out (TCO) associated with the magentron circuit, and/or ...

Carousel II back into action. I really need to be able to repair this unit. Thanks for your help. Let me know if you need further details. The touchpad has its own fuse which has probably blown due to

magnetron tube (the microwave source), the other is on the cooking cavity. These sometimes go bad. There's also a power line fuse that may have failed, or become loose in its mounting clips. These can