Question about 1995 Honda VF 750 C Magna

1 Answer

Bike wont run after washing it

I have a 1995 honda magma motorcycle i washed the bike down and now the lights all work but wen i go to start it all the lights dim and it wont start what is the problem and how do i fix it?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

You have a bad connection or bad battery or bad starter just replaced starter on an 1986 700 magna same thing

Posted on Aug 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Honda CBF1000 ABS FI light on


Hi, Victor it should be noted that the reasons your FI light stays on constantly or flashes and your bike will or will not start and may turn over or not, these conditions will vary from bike to bike depending on the year, make, and model and you should always refer to your owners/service manual for proper diagnostic procedures. It should also be noted that any type of prior work done to the bike or an abnormal event occurrence IE: adding accessories, electrical curiosity/adventures, laying the bike down/crashes, rain storms/bike washings just before FI light issues started can be significant hints/aids into tracking down the gremlin. The newer the bike the more sensitive the ECM becomes and will not let the bike start when aftermarket accessories have been installed without being reprogrammed. That being said the usual suspects are:
1. Faulty Fuel Pump, fuse or system relay switch.
2. Battery starting to fail due to old age/damage, perform a load test.
3. A discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Faulty safety switches/sensors: run/off, ignition, clutch lever, neutral, side stand, tip over, fuel, and or their connections.
5. Broken wire or worn insulation exposing wire to a ground situation especially inside wire harness at tight bends around fairing brackets, under dash panels, under fuel tanks over cylinder heads etc. Many harnesses are open on the ends that will allow water to enter and accumulate at v-bends.
Dielectric grease and contact cleaner are your best friends for wire/cable/harness connectors, look for corroded, broken, or loose pins/sockets.
6. Installation of aftermarket accessories ie. exhaust systems, mufflers, air cleaners, fuel tuners, electrical component etc.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
FI Light How To Read Error Codes
Honda Motorcycles Fault Codes
Haynes Honda CBF 1000 Motorcycle Manual $20
https://www.partsfish.com/page/oem-parts-for-honda
Honda 2006 CBF1000 Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 19, 2018 | 2010 Honda CBF1000 ABS

1 Answer

Fuel injection system on honda xl700 v fi light comes on when turning the engine and bike wont start. let it stand awhile then bike starts


Hi, Peter it should be noted that the reasons EFI lights constant or flashing, will or will not start, turns over or not conditions varies from the year, make, and model and you should always refer to your owners/service manual for proper diagnostic procedures. It should also be noted that any type of prior work or event IE: adding accessories, electrical curiosity/adventures, laying bike down/crashes, rainstorms/bike washings just before EFI light issues started can be significant hints/aids into tracking down the gremlin, also carry the appropriate jumper wire to access fault codes to reduce the risk of being stranded or towed, that being said the usual suspects are:
1. Faulty Fuel Pump, fuse or system relay switch.
2. Battery starting to fail due to old age/damage, perform a load test.
3. Discharged battery, check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Faulty switches/sensors: run/off, ignition, clutch lever, neutral, side stand, tip over, fuel, and or their connections.
5. Broken wire or worn insulation exposing wire to a ground situation especially inside wire harness at tight bends around fairing brackets, under dash panels, under fuel tanks over cylinder heads etc. Many harnesses are open on the ends that will allow water to enter and accumulate at v-bends.
Dielectric grease and contact cleaner are your best friends for wire/cable/harness connectors, look for corroded, broken, or loose pins/sockets. For more information about your issue please visit the websites below. Good luck and have a nice day.
Honda Transalp XL700V Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda XL700V Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Oct 03, 2016 | 2008 Honda XL 700 V Transalp

1 Answer

No power after washing


Did you wash it with the seat off? Sounds like you got the relay wet, or fusebox wet.... take the seat off, let the bike set in the sun for a couple of hours....hopefully whatever you got wet will dry out and the bike will start.

Mar 22, 2014 | 2007 Honda VTX 1800 C

1 Answer

95 honda vf750c magna starter grinding


Hi Frank and the usual suspects are:
1. Ignition switch not in the "ON" position.
2. Engine run switch in the "OFF" position.
3. Discharged battery, loose, corroded or broken battery cables, especially the "NEGATIVE" cable at both ends (solenoid chatters).
4. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
5. Security alarm needs a reset.
6. Starter control circuit, relay, or solenoid faulty.
7. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
For more information about your issue, please visit the websites below. Good luck and have nice a day.
1995 Honda Motorcycle Service Repair Workshop Manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Apr 22, 2013 | 1995 Honda VF 750 C Magna

1 Answer

I washed the bike and it wont start now. the


have you checked for a spark at the plugs. You may well have got water in the coils.The cure for this is natural drying. if this is the case the coils will need to be sealed. and the leads silicone sprayed

Jun 04, 2009 | 1999 Suzuki GSX 600 F (Katana)

1 Answer

2005 vtx 1300r bike wont start


try looking at the fuse box . i had this problem with a customers bike and the fuse box had a crack in the pc bord that is under the fuses

May 30, 2009 | 2005 Honda VTX 1300 R

3 Answers

Bike wont start. everything works. no spark on plugs


98 honda shadow ace wont start electric switch is sticking and the headlight doesnt come on when key is turned on

May 04, 2009 | 1989 Honda VT 1100 C Shadow

1 Answer

Elecric start problem- kick start good


hi m8,, first try this, take the handle bar start button switch gear appart,,and clean the starter button terminals that connect wen u push button in,,spray some wd40 inside the switch gear wen u put it back together,,,,,often after off roading ,,connections that the eye cant see corrode wen the bike is washed down,, any probs still ,, shout and il anserw m8,,,,,cheers

Jan 08, 2009 | 2004 Yamaha WR 450 F

Not finding what you are looking for?
1995 Honda VF 750 C Magna Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5057 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...