Having a problem removing battery cover - XL 1200 C Sportster Custom Harley Davidson Motorcycles

Choose free 2-day shipping or in-store pickup.
Sign in
Home Support Samsung Galaxy J7 / J7 V Samsung Galaxy J7 V / Galaxy J7 - Remove Battery
Samsung Galaxy J7 V / Galaxy J7 - Remove Battery
Ensure the device is powered off.
Remove the battery cover.
Note With the device facing down, utilize the provided slot (right-edge), carefully lift then detach the cover.
Remove battery cover
Utilizing the notch in the lower-left corner, lift, then remove the battery.
Note If applicable, refer to Insert the Battery.
Remove battery
Replace the battery cover.
Replace battery cover
Press in on the cover to lock it into place.

Below is the procedure for an Aston Martin Vantage, perhaps the vanquish is similar?

Removal
1. Power the driver's fully forward.
2. Remove rear compartment cover.
3. Loosen and disconnect battery terminals, earth (- ve)
terminal first.
4. Release rear carpet, studs (x2), move carpet aside.
5. Remove screws (x2), battery compartment cover to
support rail.
6. Remove nuts (x2), battery compartment cover to body.
Remove cover.
7. Remove Torx screws (x4), remove battery clamps (x2).
8. Disconnect battery vent tube.
9. With assistance, remove battery.
Installation
1. Clean battery tray and clamps.
2. With assistance, install battery into its compartment.
3. Connect battery vent tube.
4. Position battery clamps (x2), install and torque tighten
Torx screws (x4).
5. Ensure battery vent tube is not distorted by battery.
6. Install battery terminals, tighten terminal nuts to correct
torque.
7. Install battery compartment cover, install and tighten
screws (x2) and nuts (x2).
8. Position rear carpet, secure with studs.
9. Install rear compartment cover.
10. Reposition driver's seat.
Courtesy of pistonheads.com

Please vote if this helps! Thanks, Mike

Determine that you do have a Garmin GPS with a replaceable battery. Find the information by checking the manual or with a close inspection of the back and sides of the GPS unit. GPS units that have a battery that can be replaced by the owner will have a battery cover lock on the back or side; it looks like a small sliding piece of plastic with slots or ridges.

2 Open and remove the battery cover by sliding the battery cover lock and pulling off the battery cover. In some models, you may have to hold the lock up while simultaneously pulling the battery cover off.

3 Remove the battery by sliding the battery out of the battery cavity. You may need to use gentle pressure to get it to slide out.

4 Put the new battery in by sliding it into the battery compartment. Line up the metal contacts on the battery with the metal contacts in the battery compartment to make sure it is properly installed.

5 Click the battery cover back into place. The battery cover lock should automatically lock and secure the cover. If this does not happen automatically, slide the lock back to the locked position.

There is no instructions.Remove the cover nut's and keep those carefully.u can remove battery cover after that.

hi..
1. Turn your device off and remove the battery cover and battery
2. Remove the end-cover by pushing the cover away
3. Pull the bumper tabs up to separate the bumper from the device and remove bumpers
4. Snap new bumpers firmly into place
5. Re-attach the end-cover, re-insert the battery and re-attach battery cover..

thank u
rate me!!!

1. Turn your device off and remove the battery cover and battery
2. Remove the end-cover by pushing the cover away
3. Pull the bumper tabs up to separate the bumper from the device and remove bumpers
4. Snap new bumpers firmly into place
5. Re-attach the end-cover, re-insert the battery and re-attach battery cover

Remove the battery cover. To do so, press the ridged area on the battery cover using your thumb (1) and gently slide it in the direction of the arrow (2). Remove the battery cover.

Place the battery so that the three brass tabs on the end align with the three brass prongs at the bottom of the battery compartment (1). Press the battery down until it clicks into place (2).

Replace the battery cover. Make sure that the battery is properly installed before switching on the handset.

Thanks.