Vehicle manual says put 1150 ml. Secondly it says to fill up till the maximum level mark. If I fill up to the maximum level mark, I can put only 800 ml of oil.What is to be followed.

Ignore the instruction manual. Instead look at the measuring cup that comes with your Hyundai PLU 247959 (produced and sold under license by Poundstretcher).
On the side of the measuring cup, you can see three clusters of marks:1. 25 to 40 ml for soft-boiled eggs (symbol of egg with two horizontal lines)2. 45 to 60 ml for medium boiled eggs (symbol of egg with one horizontal line)3. 65 to 80 ml for hard boiled eggs (symbol of egg)
Egg boilers are based on the principle that the larger the volume to be heated is, the less water is required. In other words, you will need to add less water for boiling seven eggs, and more water for boiling one or two eggs.
Which means that for seven eggs to soft boil, add 25 ml; and for one egg to soft boil, add 40 ml. If you look at the markings, you'll notice that on the vertical line between 40 and 25 ml, there are seven equidistant horizontal lines, each showing the amount of water required for the various quantities of eggs.
One egg = fill with water up to the 40 ml markTwo eggs = fill up to the mark below the 40 ml markThree eggs = fill up to the second mark below the 40 ml markFour eggs = fill up to the third mark below the 40 ml mark etc, untilSeven eggs = fill up to the 25 ml mark
Medium boiled and hard boiled eggs are measured in similar ways. Works every time for me. Nice little egg boiler, by the way.

you measure the trans level by pulling the trans dipstick with the car warmed up (after a short drive), on level ground, engine running-it should read within the 'hash marks' on the dipstick to be considered correct

put a 50/50 mix. remove radiator cap when cold,start car let run 1 min and dump 50/50 mix till full, a little will come out cap when thermostat opens this is normal,when thermostat opens coolant will go down,continue to fill till full,put cap on and fill reservoir to cold mark,check reservoir after you run a day and fill if needed to the full cold mark again

With the vehicle off and front wheels off the ground do the following:
fill the reservior to mark on dipstick turn steering wheel lock to lock 20 times slowly each side (try to maintain fluid level) check fluid and fill if necessary start vehicle check fluid and fill if necessary turn steering wheel lock to lock 20 times slowly each side (maintain fluid level) shut vehicle off check fluid level if bubble exist in fluid (creamy color), wait five minutes and repeat from "start vehcle" (i.e. check fluid... turn wheel lock to lock 20x, etc...) repeat till bubbles are gone

Locating the Power Steering reservoir and adding PS fluid. 1999 Pontiac GP

The reservoir is clearly visible in the engine bay on the 3.1 litre engine cars.

For the 3.8 Ltr engine cars, use a flashlight to look down past the alternator for a black cap with a steering wheel printed on it to indicate the power steering fluid reservoir. ( passenger side of the vehicle).

Remove the cap of the power steering reservoir, clean the dipstick, re-insert and remove again to check the fluid level. If the level is at or below the low level mark, add fluid slowly, taking care not to fill above the MAXIMUM mark. It's best to add small amounts and re-check the level as you go to ensure you do not overfill the reservoir above the MAX level.

ONLY use the power steering fluid recommended for that vehicle by GM.

this sounds like your tranny is low on flewed if your vehice had a dipstick for the felewed check it to see if its low if it is make shour that the vehicle is on level grond and fill the tranny to the full mark onthe stick (remember if your cars engine temp gage is on cold fill to the cold mark)

to fill the tranny fill it little bit by little bit not all at once and have the engine running while filling after putting in a bit of flewed get in the car and shift threw all the gears slowly then check the dip stic and put in a bit more if needed and shift the gears agane and do this till the tranny is full wate a few minits then shift the gears agane then take the car for a short drive around to see hoe itshifts threw the gears

i hope this helps

Hello. The engine and the trans do NOT use the same oil. The engine oil is premixed with the fuel. The transmission oil is filled with the filler plug on the right side of the engine case. Look under the kick stand, see the 850 ml marking? The trans holds that much oil. Either drain the oil and add that exact amount.... OR you can take out the check screw located lower and forward of the oil fill on the case, should look just like a case bolt, but with an aluminum washer to seal it. Once you remove this bolt/plug you can add oil till the oil flow out this hole. Joe

Always use Hero Honda 4T plus 20W40 Engine oil and after filling this oil, next oil replacement is after 4000kms.

Oil Filling Procedure: Drain the Old oil and tell the technician to remove the clutch case and remove the rotor and clean the clean the rotor, and then while fitting the clutch case need to replace the rotor gasket and clutch gasket.

Fill only 900 ml of Engine oil, and maintain the Engine oil level between minimum level to maximum level

fork oil type -fork oil#10, oil capacity each leg 388 ml for E-01,28 33 models and 392 ml for the other models standard oil level 142mm for E-01,03,28,33 138mm for the other models

On 91 vehicles there's a 17mm allen screw on the side towards the left front wheel. Open it add the oil there on a level surface and fill till oil reaches the hole and starts coming out. DO NOT FILL OIL FROM THE TOP where what seems to be a plug. It's actually the timing marks and houses the clutch. Put oil there and you'll need a new clutch.