I purchased a harley shift light for my 2006 ultra. I need to connect a wire from shift light ti a tach signal source. where is this?
The source wire should be a pink wire. The location should be under the fairing. It will have a white plastic bullet type connector on it. I believe it's on the top by the speedo if it's been installed. If not then the pin location on the speedo should be said in the directions, and a long pink wire usually comes with it. You have to pull the speedo plug off and install the pin in the connector.
I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb
SOURCE: turn signal wiring
SOURCE: 2006 Harley Street Glide turn signal problems
hi, if you have not yet fixed the problem , the fuse box is located underneath the left sidecover in front of the left sattlebag youll need to remove the bag to get the side cover off ck the fuses thats all it should be ,prolly what happened was a bulb went bad and shorted the circut blowing the fuse for them theyre on the same fuse as the tach and speedo
SOURCE: having trouble changing a kick stand spring on my
well the easy way is to jack up bike remove the nut jiffy stand slide it out hook spring slide it back in and tight nut hope this helps
SOURCE: I'm installing a harley mini tach ( 3 wire ) on my
There should be a light green or violet wire coming from speedometer this is your database wire. This is were you hook up your last wire. Hope this helps, from 04-to 07 the wires are pretty much the same color.
wires from speedometer:
light green/ violet = database
black= ground
orange/white= inst power+12vdc
SOURCE: harley 1998 ultra wiring schematic
Sorry but I don't have a wiring diagram that I can send you but I may can offer a bit of help.
Your passing lamps are simply wired into a hot circuit somewhere. A lot of schematics don't show them because they are considered "add ons". They also may have a fuse inline with the "hot" wire. They have only one wire that connects them to the bike with the rest being inside the "light bar" itself. Find the wire coming out of the center of the "light bar" and trace it back to where it hooks up. Sorry but that's the best I can do on this one.
On your front brake light, there is a switch located inside your right hand switch housing where your throttle is located. It is a plunger type switch that is activated when you pull the front brake lever. A simple test of the switch is to loosen the bolts of the master cylinder and slide it towards the center of the handlebars. If the switch is good, the brake light will come on. If the switch is bad, it will not.
To get to the switch, you'll have to take the right hand switch housing apart. First, loosen the throttle cables at the adjusters and then remove the two bolts that hold the switch housing halves together. Carefully open up the switch housing. You will see the small switch in the front of the housing. You'll have to desolder the wires, replace the switch with a new one, and resolder the wires to the new switch.
Reassembly is the reverse of the disassembly. Make sure you slide the master cylinder all the way back against the switch housing or the brake light will stay on constantly. Readjust the throttle cables and check for proper operation. You don't want your throttle sticking.
Good Luck
Steve
170 views
Usually answered in minutes!
×