Recently had a slow spill, no damage, but now my lights don't work, all fuses sound, stereo and flashers work, engine runs, but that's it. Any clues, please.
SOURCE: Brake lights
The taillight should be on at all times. The brakelight should come on when the front or rear brakes are applied. Start by disconnecting the front brake light switch then the rear to see which switch is broken. Also check the bulbs. I have seen them short out internally. The filament inside the bulb break and contacts the other circuit.
SOURCE: RVF 400R MISSING WHEN YOU REACH 6000RPM
you have to take time and check all your wires for breaks and to look for cutts in them.Check your handlebar swicthes .change your bulbs . Replace or ajest your brakelight swicth. You need to take off your carbs. and supmerge them in yamaha carb. cleaner in a deep pot. there cleaner does not hirt rubber.
SOURCE: honda goldwing indicators not working
How about a link to the manual just scroll about 1/4 way down the page and you can view or download which ever one you need for free.
SOURCE: 1990 Honda Goldwing GL1500 lights go off when put in gear.
We had the same thing tonite. thanx to the guy that pointed us in the right direction.
More specificly, if you remove the seat, you will find two black plastic boxes, one on each side. they hold a 30-40 pin connector. the one on the left side (as you are sitting on it) we found one burned connection in the corner of the plug. a green wire. we cut the wire off both sides of the plugs & made a jumper (bypassed the plug) works good, even the cruise works now too.
hope this helps. now we can relax & have some beers EH!!
SOURCE: bikes been dropped and need to reset fi light, how??
Hi and welcome to FixYa,
Initially, check / bypass or replace the bank angle sensor.
Good luck and thank you for asking FixYa.
62 views
Usually answered in minutes!
×