My Honda CBR 600rr 2005 after riding of 1 or 2 km engine cuts off and if we switched off the ignition and on it again then it works tell me the reason..thanks and regards Muneeb Rasheed
SOURCE: my honda cbr 600rr 2005 will not start the hiss
1. Obtain a new transponder key.
2. Grind the key in accordance with the shape of the original key.
3. Apply 12V battery voltage to the ignition pulse generator lines of the engine control module (ECM).
4. Turn the ignition switch ON with the original key. The immobilizer indicator comes on and it remains on.
*The code of the original key is recognized by the ECM.
*If there is any problem in the immobilizer system, the system will enter the diagnostic mode and the indicator will remain on for approx. ten seconds, then it will indicate the diagnostic code (page 20-5).
5. Disconnect the red clip of the inspection adepter from the battery positive (+) terminal for two seconds or more, then connect it again. The indicator remains on for approx. two seconds, then it blinks four times repeatedly.
*The immobilizer system (HISS) enters the registration mode. Registrations of all key except the original key inserted in the ignition switch are canceled. (Registration of the lost key or spare key is canceled.)
NOTE:
The spare key must be registered again.
6. Turn the ignition switch OFF and remove the key.
7. Turn the ignition switch ON with a new key or the spare key. (Never use the key registered in previous step.) The indicator comes on for two seconds, then it blinks four times repeatedly.
*The new key or spare key is registered in the ECM.
*If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain on for approx. ten seconds, then it will indicate the diagnostic code (page 20-6).
CAUTION:
Keep the other transponder key away from the immobilizer receiver more than 50mm (2.0 in).
8. Repeat the steps 6 and 7 when you continuously register the other new key.
NOTE:
The ECM can store up to four key codes. (The four keys can be registered.)
9. Turn the ignition switch OFF, remove the inspection adapter and connect the ignition pulse generator connector.
10. Turn the ignition ON with the registered key.
*The immobilizer system (HISS) returns to the normal mode.
11. Check that the engine can be started using all registered key.
If that doesn't work,You will need to go to a dealer and have the keys reprogrammed.
SOURCE: how to install a 2008 honda cbr 600rr radiator
first take off gas tank so you can access radiator cap......just lossen it..then find drain plug and let her rip..i by the way race my bike on and off and use Kool-Aide as a substitute because of racing requirement and have had no trouble with it.runs a little cooler actually.get all those fairings out of the way and it should be very simple.
SOURCE: I am putting a cbr 600rr motor into a 2006 yfz 450
Hi and welcome to FixYa,
Have you tried here?
Good luck and thank you for asking FixYa.
SOURCE: when do i have to change the oil??
its best to change the engine oil after the first 500 miles then again at 1000, by then it wont realy matter to much so long as its done twice yearly as they have very soft cam shafts
275 views
Usually answered in minutes!
×