I have a 2001 Chryler Concorde with a 2.7L engine. The engine light came on a gave me 2 codes... PO700 and PO605.. Can you help me by telling me what i can change?

po700 automatic transmission control system malfunction. code po605 engine control module ROM error. code p1192 inlet air temperature circuit low.

that is the transmission control module is not reading. did you replace it. it is in the front of the transmission

P0605-------- Internal control module read only memory (ROM) Error
Have the computor checked.
P0700-------- Transmission control system
Better take it to a transmission shop and have that checked so they can pinpoint the problem.

the 605 is an internal Tranny computer failure U will need a tranny computer no way around it. It will also need to be programed as well once installed.

p0700 also has to do with the transmission

The P0605 is an internal failure in the transmission controller. This code sets when the tcm fails one of its internal self tests, and i think the only repair is to replace the module. P0700 is transmission control system malfunction

all this code means is that the Transmission computer has asked the engine computer to turn on the check engine light, now u must have the Transmission computer tested to determine the reason the check engine light was turned

po356 ignition coil #6 primary circuit
po700 transmission control module
po1391 loss of cam or crank sensor signal
po1793 communication error
check your transmission fluid
replace the cam sensor

po700 is the code in the pcm,telling you there is a code in the tcm( trans control module) po605 is a internal tcm error replace and program the trans control module

its fuel injected, so there are two actually. main one will be under the body, on drivers side i think, near the rear door. ther is also a small on in the fuel rails on top of the engine where fuel is dellivered to the injectors. under carriage one is easy.....other one is not

p0700 is a generic trans. code, so the problem if it is in the trans. would require further trans diag. so i would scan trans specific codes first. but in most cases when a chrysler tells you it is an internal controller fault you can believe it. just make sure which controller it is telling you has a fault!