My amber runing lights and tail lights dont work but hazards and brakes work . just no running lights at all? is there a relay from my switch on the colum to the lights that im missing. All fuses are good

The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com/

Check all ground points in the trunk area. Sometimes too the bulbs will corrode in their sockets and stop electrical current from making contact...so take the bulb out wire brush conacts and then use die-electric grease on surfaces.

I assume the fuse has power if the hazards work.
The third brake light skips the turn signal switch, the regular brake light circuit goes thru the turn signal switch.
Do you have power going into the turn signal switch on the red lite green wire from the brake switch ?

I would check for voltage at the turn signal switch. The brake lights go thru the turn signal switch, except for the high mount light.

There are several components of your 1997 Subaru Outback that can cause your tail lights to stop functioning correctly. To help pinpoint the cause of the problem, it would be very helpful to also check your front marker lights. If the marker lights are working, then we know that the problem is not the headlamp switch or the tail and illumination relay (located in the fuse and relay box).

The components to check are:

> Fuse #23 (20 Amp) in the Main Fuse Box.
> Fuse #5 (10 Amp) in the Fuse and Relay Box
> Tail And Illumination Relay
> Headlamp Switch

will u have a few more switches and relays to check/change brake light switch and relay/and headlight switch

The brake light wiring runs through the turn signal switch. I'd check that for problems. (usually a melted connection in the switch itself.)

I've worked on these the first drove me crazy. its the turn signal switch every thing runs thru these. head lights, turn signal, brakes. except the third brake light. it runs directly from the brake switch. go figuare

check the conectors in the fender wells

TEST FRONT RIGHT BLINKER CIRCUIT AND REPLACE THE BULB,,WITH PROPER BULB...A DOUBLE CIRCUIT BULB IN A SINGLE SOCKET WILL DO THAT ALSO A SINGLE SOCKET BULB IN A DOUBLE SOCKET HOLDER....CHECK LEFT SIDE BULB FOR ACURANCY