The camshaft position sensor (also known as the distributor pickup) is inside the distributor which is driven by the camshaft gear and directly below the water pump, the water pump must be removed to access the distributor to change the sensor. Here is a picture of the camshaft position sensor.
SOURCE: cam position sensor
should be a 5-volt reference signal from the pcm (engine computer). if you dont have power at the sensor, you may have a broken wire.
SOURCE: 2002 Chevy Trailblazer Engine Codes
This is actually an easy swap out. Remove the electrical connection, remove the retaining bolt and pull out old one. I believe the sensor is located in the front passenger side of the engine on this particular model.
SOURCE: 1997 chevy tahoe,misfiring and i replaced the cam
most CPS switches need to be an exact distance from crank. try moving it a little & try running it again. good luck.
SOURCE: were is the crank position sensor located on the
on the timing cover near the front of crankshaft
SOURCE: 1997 ford ranger cam shaft position sensor
If you have the 3.0 L or 4.0 L V6 engine, the cam position sensor is located on the top rear of the engine. If you have the 2.3 L 4 cyl. engine, you will find it on the left front of the engine behind the oil pump pulley.
Zoom
1997 Volvo 960 Crankshaft Position Sensor Beck Arnley
BECK ARNLEY ENGINE CRANKSHAFT POSITION SENSOR -- A high quality,
direct fit OE replacement engine crankshaft position sensor.
Condition: New
FITS (ENGINE/CHASSIS)
SKU
PRICE
QTY
1997 Volvo 960
BEC1800432
$49.85
11,438 views
Usually answered in minutes!
×