SOURCE: Changing blinker on 2007 Pontiac G6
It's a monster pain to get to them, but it's doable. Once you empty the trunk, you'll see 4 black knobs - approx 1.5 inches in diameter. You'll need to remove all of these (they just unscrew, but they are plastic, so be careful not to strip the threading) in order to access the rear light assembly.
They're in there snug, but once you find the appropriate sized socket (I wish I could recall well enough to tell you what size, b/c I remember that it WAS an odd size), you'll have to remove all 3 bolts and then push the whole assembly out from inside the trunk.
Once the assembly is out, you will see the rear of the sockets, which simply push and turn to get the lamps out of. As long as you have everything open, I suggest changing ALL of the lamps (brake, tail, and turn signal) on BOTH sides, since the lamp life for all of these is about the same and it's such a pain to get to them in the first place.
SOURCE: need diagram how to install serpitine belt on 1997 pontiac bonneville se 3800
8th digit of your vin# needed. Is it an "L", "C" or "K" ?
SOURCE: need diagram how to install serpetine belt for my 1997 pontiac
What engine do you have in the bonnie? Supercharged or non? Belt routings are different...if you have an owners manual it will be in there.
SOURCE: diagram for installing serpetine belt 1987 ford 4.9 liter
Belt removal instructions (and routing information) may be found on a sticker under the hood. I have posted a picture of the diagram below if these instructions have faded. The routing on the left is without the AC.
SOURCE: need diagram to replace serpetine belt on 1995
should be on the underside of your hoos or on your rad support
225 views
Usually answered in minutes!
×