The turn signals work intermitantly

If a sound is occurring then there should be power at the switch. Check under the seat and make sure the plug into the seat adjustment motor is fully connected to the motor. (there may be 2 motors so be sure to check both motors). If not then reinstall the plug back on the motor(s). It should work fine.

its probly under the hood in a little black box it should say fuses if not there check under the dash on the drivers side

the signal indicator lights are suppose to flash in perticular time interval which is connected to a timer relay when the light flashes faster that means the other light is not working and the relay is getting double the current and moving faster so check the other light either the bulb is fuse or the current is not reaching up to the bulb

I would replace the blower motor speed control switch.

You'll have to contact your local dealer with your VIN and they can check for any outstanding recalls on your vehicle and give you an appointment to have the work done. Only a dealer is authorized to do recall work and the work would be done for free.

CHECK BULS FRONT AND BACK IF BULS ARE OK CHECK FUSES , IS EVERYTHING SEEM S OK YOU NEED TO REPLACE THE SIGNAL LIGHT SWTICH

The turn signal flasher is worn out. The turn signals have their own flasher. It is usually on the drivers side of the vehicle under the dashboard. It is normally a cylinder about 1 inch in diameter and 1inch tall that has two prongs on it. My advice would be to go to the parts store and get a new turn signal flasher for your car. Look for something under the dash that looks like it and exchange them.

check your accessory relay. Hopefully it isn't your power module. $1000 fix at chrysler. :(

I would take to a reputable mechanic to have a diagnostic performed. Sounds like you have a serious electrical problem.

That is not a code, It is a GET ME CHECKED OUT SOON attention flash. If you hacve an AutoZone auto parts store in you r towm/area, go to them and ask them to put the code reader on the car. Then ask them to make a list of the codes and the definitions. Advice can be given better then. Hope this helps you along a bit.