How do you remove the armrest on the front seats?

Pull the armrest vertically up. There is a slot in the armrest and a pin on the frame. You have to match these to pull the armrest off. Without a zipper it's a little more challenging. Some armrest have a little screw that keeps the armrest on the frame. The older models usually worked with the slot and pin.

there are about 8 torx screws (very small) near the hinge of the lid. remove those and the lid will come to remove the entire console, there are bolts on the back of theconsole accesible from back seat, and on the side of the console. easiest way to acces those bolts would be to remove the front two seats. they are held in by two bolts in front and two nuts under plastic covers in the back. raise the emergency brake lever and the console will slide up and be removed.

Armrests are part of door panel. Usually has holding screw in handle itself then pop panel off as one piece.

1. Remove the two oval covers from the sides of the floor console. Remove the four (two on each side) retaining bolts. Lift or remove the front seat center armrest from the floor console.
2. Remove one screw from the top rear end of the floor console (directly under the front seat center armrest.
3. Remove four screws retaining the utility tray beverage holder to floor console. Lift or remove the utility tray beverage holder from the console.
4. Remove two screws (directly under the utility tray beverage holder) retaining the front end of the floor console to the console panel front mounting bracket.
5. Lift the floor console from the front and rear console panel mounting brackets.

Rear
See Figures 3, 4, 5 and 6

1. Remove the lower seat cushion by pulling straight up on the front portion and disengaging the clips. Then hinge the seat upward to release the rear clips.
   

Fig. 3: Pull up on the front of the lower seat cushion and disengage the clips

1. Remove upper rear seat back-to-chassis bolts.

Fig. 4: Remove the bolts behind the center armrest ...



Fig. 5: ... and the bolts on the lower corners ...



Fig. 6: ... Then pull up on the seat to disengage the three clips on the top of the seat

1. Remove rear seat back by tilting forward and pulling straight up.
   

To install:

1. Install the lower seat cushion and torque the lower rear seat-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm).
2. Install the upper rear seat back cushion and torque the upper rear seat back-to-chassis bolts to 15-20 ft. lbs. (21-26 Nm)

Hope help with this (remember rated this).

all bronco II's that i have seen have 2 bucket seats up front and 1 bench in the back that usually had 3 sets of seatbelts.

Base Console, Floor, Ranger, Explorer Removal and Installation

1. Remove the two oval covers from the sides of the floor console. Remove the four (two on each side) retaining bolts. Lift or remove the front seat center armrest (644A22) from the floor console.
   

1. Remove one screw from the top rear end of the floor console (directly under the front seat center armrest.
   

1. Remove four screws retaining the utility tray beverage holder to floor console. Lift or remove the utility tray beverage holder from the console.
   

1. Remove two screws (directly under the utility tray beverage holder) retaining the front end of the floor console to the console panel front mounting bracket.
   

1. Lift the floor console from the front and rear console panel mounting brackets.
   

Un zip the cover on the armrest and pull it up to expose the bolt hole. unbolt and remove the arm rest and see what parts are damaged, sometimes it can just be tightened.

F150 seat should work in the 94 bronco if not you could remove thebraces and sliders of the bronco and put them on the other seats..

if there is no plug then just pop off the lower radiator hose at the radiator. then the fluid will drain