I have a 2001 Chevy Suburban 2001. the driver

Check your fuses and relays, did they all stop working at the same time, any recent work done, accidents, etc.

How to fix the Chev power window door lock switch - YouTube

? 5:04
https://www.youtube.com/watch?v=XDKaDURD8Sc
Jul 13, 2013 - Uploaded by spelunkerd
How to fix the Chev power window door lock switch ..... Some time later my drivers side window stopped working in the down position. ... These intermittent electrical problems are frustrating,aren't they? .... How To Install Replace Door Locks Chevy GMC Truck Silverado Sierra Yukon Tahoe Suburban ...

Diagnose Power Door Locks Dont Work Properly - Auto ...

www.auto-repair-help.com/.../diagnose_power_door_locks_dont_work_...

An inoperative power door lock can be caused by the switch, solenoid, wiring problem or ... Hi, I have a 2005 Nissan Sentra and the power locks aren't working. .... Hi, mypassenger door locks/unlocks both doors but my driver side door works independently and .... I have a 1986 Chevy Silverado K10 with auto door locks.

SilveradoSierra.com • 2003 silverado no power in right door ...

www.silveradosierra.com/.../2003-silverado-no-power-in-right-door-t30...

That info is on the owners manual, if you don't have the manual you can download one for free at the GM owners site by clicking HERE

uses crappy cable drive for windows..will need replaced

after you get your new switch, pop off the switch pannel on the door by pulling on it. (should come out easily because its only held in by clips) take out the conectors ussing a small flat to lift the tabs and put in the new one. good luck

sounds like the alignment on the windows is bad just my thoughts

check all power outlets for loose change or metal objects in the doubble check the rears. fuse should be located on drivers side fuse pannal on side of dash

Hi there,
Try replacing the button that you push up and down. It could be bad under it and not making the connection. Maybe take the panel off and take the switch off, then clean the connecters under the button. Maybe that will do it. Also, you probably already ckeched this, but is the window off track? Well, good luck and let me know. Have a great night.~MWD

Unplug the connector at the rear wiper motor, turn the switch on and probe the wires with a test lamp, if you have power back there you more than likely have a bad motor. If there is no power start checking fuses they are all labeled easily on the back side of the fuseblock covers both on the dash and underhood. Good Luck!!!

as long as nothing is stuck in track and you hear no noise when using switches, look for broken wire at connector or in harness. ck fuse first of course, if blown, something may be stuck in track causing it to stop and blowing fuse