You have a bad blower relay or power going to the relay. The blower relay is located to the right by the motor mounted on the firewall. It will have three larger wires from the relay and two smaller wires. you will need to unplug the connector and check the red wire for +12 volts. If it has voltage then replace relay. if connector looks melted or burnt change connector and relay together.
More then likely it's a resistor block, they tend to fail one step at a time like your's is.
The block is up under the dash, unfortuneately I can't show you, but your local garage, depending on whee you live shoudn't charge over $150 for the job, always ask for an estimate. Then check other garages to verify the cost.
I hope this helps you out.
Thanks for letting FixYa.com...fix ya
Terry
The actual switch is the culprit. Replacing this damaged resistor switch will correct this issue.
609 views
Usually answered in minutes!
×