2010 town and country nurtrial safety switch how do you relate

You need to replace the rear latch assembly it sounds like the switch inside latch is going bad.

check this out
https://www.google.com/search?q=2010+chrysler+town+and+country+Speed+Sensor+location&rlz=1C1NHXL_enUS713US714&oq=2010+chrysler+town+and+country+Speed+Sensor+location&aqs=chrome..69i57.50489j0j9&sourceid=chrome&ie=UTF-8

Refer to you tube !

Chrysler Town Country 2008 2010 Shop Service repair manual


for better result of your problem click the link

The Hazard Warning flasher switch is located in the center of the instrument panel above the radio. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher. This is an emergency warning system and should not be used when the vehicle is in motion. Use it when your vehicle is disabled and is creating a safety hazard for other motorists. When you must leave the vehicle to seek assistance, the Hazard Warning flasher will continue to operate even though the ignition switch is OFF. NOTE: With extended use, the Hazard Warning flasher may wear down your battery. http://cdn.dealereprocess.com/cdn/servicemanuals/chrysler/2010-townandcountry.pdf

Probably needs the fuel safety shutoff switch resset. I am not sure where it is on a Town and Country van.

if you are jumping it at the plug to the pressure sensor when it comes on, your new switch is probably bad.

is the neutral safety switch locatedn on the same place as on a 2006,vs 2002

It is built into the valve body of the transmission. It can be replaced, but it should be done by a pro. What are the symtoms that make you ask>

Safety neutral switch o.k.? Tried moving shifter through all gears while holding key in start position?