1998 Oldsmobile Silhouette Logo

Related Topics:

Anonymous Posted on May 17, 2018

How to disarm my factory alarm 98 olds Silhouette?

Door key and iqnition won't stop the alarm since broken into ,can I just unhook it

1 Answer

cartoys4u

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

  • Expert 66 Answers
  • Posted on Mar 07, 2019
cartoys4u
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Joined: Jun 18, 2009
Answers
66
Questions
2
Helped
14812
Points
176

In the drivers door there is a wire hooked to the lock cylinder. if you ground this wire permanently it will disable the security system.

5 Related Answers

Carlos Rojas

  • 119 Answers
  • Posted on May 21, 2008

SOURCE: ECM location 1998 Oldsmobile Silhouette

On the 98 Silhouette, the PCM should be located in the air filter housing.

Ad

kevin bulsara

  • 234 Answers
  • Posted on Aug 06, 2009

SOURCE: How do I disarm a 1995 Mitsubishi Galant alarm

to re set i think u remove wires from battwey put live wires to negative for about a minute the then replace

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Jan 04, 2010

SOURCE: factory alarm disarm

dealer only ,its built into the ECU have you pushed the fuel cut off switch back down to reset it ?? under the bonnet with a red rubber top on it about an inch square

Anonymous

  • 193 Answers
  • Posted on Feb 23, 2010

SOURCE: how to disarm factory car alarm on a

Lock and unlock the driver's door with the key.

Anonymous

  • 1 Answer
  • Posted on Apr 19, 2010

SOURCE: 98 honda accord car alarm will not let car start.

Try chaning the main relay. It is $60 at the dealer, cheaper on e-bay. There is also a way to repair the sodlering connection on it if you want to try and save some money. Check youtube for a video on how to rapir main relay on Honda's. Any questions, e-mail me at [email protected]

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

How to disconnect the factory alarm

not sure if your having problems with factory alarm but if it is malfunctioning it most likley will again so here it goes...... to reset alarm insert key in drivers door turn key left then turn key right this should disarm and reset the factory alarm. to disable the factory alarm for good in the drivers door wireing harness look for the factory alarm disarm wire it should be dark green/purple with a negative polarity when your sure you have this wire splice a wire of the same size into it and ground the other end to the frame make sure that you have a good solid ground here and thah where you spliced into the wire is a good connection. this should terminate the factory alarm function hope this helps you
0helpful
1answer

How to disable 98 civic alarm keeps drain battery

Might have broken wiring harness wires that run from the cabin to the door. There is a rubber boot that covers this harness, runs near the door hinges, remove boot and check all wires and if you find any damaged or broken, repair and test auto door lock.
0helpful
1answer

Please can someone tell me why my door key will not disarm my 1996 olds aurora factory alarm system

Hello! There is a "pellet" in the key...A resistive pellet...Question is, have you tried another key? If more than one key has the same fault the ignition key cylinder is defective...Or the connector plug to the cylinder has dirty or broken pins/wires...However if it is just that one key a trip to the dealer to acquire a new one is in order...That connector has two wires...Colors are...Purple/White and White/Black...Send a comment...Guru...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

0helpful
1answer

Anti theft system nissan problems frontier

if its a factory alarm you can disarm it by locating the disarm wire and grounding it out. try www.wirewerx.com for a diagram
0helpful
1answer

How can i get my alarm to stop going off and dis arm it without un hooking my battery without using my remote since my theft system/ auto starter is outdated without going to the shop. 2000 pontiac...

most aftermarket alarms have a valet button and in the case of lost or broken key fob the button can be held or pressed when the ignition is turned on the turn alarm off. if it is a factory installed system usually opening driver door with the key will disarm it
1helpful
1answer

Every time I open driver side door the alarm goes off but not the passenger side. I put key in ignition it stops. What can I do to stop it.

stop locking the door with the lock button while the door is open. That engages the factory alarm. You can also use the key in the driver door lock to disarm the system
2helpful
2answers

How can i disarm the factory security alarm.i have tried the key locks. i have no remote with the car. i didnt know it had an alarm when i bought it . 1995 chrysler cirrus

Here is what I do on my 95 Cirrus I also do not have a keyless remote (well I do but is broke) and after frustation after frustation trying to disarm the factory alarm I find out that by unlocking the passenger front door with the ignition key from the outside will disarm it you may have to try few times before it's disarmed you need to make sure that the blinking red light stops blinking and all of the locks on all 4 door are up or unlocked, this is what I been doing for 3 years now and that's how I disarm the alarm on my car, I hope this helps.
0helpful
1answer

2001 olds silhouette non functioning alarm

red light? this is a factory alarm?? Is GM on the key fob? factory alarms dont have "motion sensors" and very few aftermarket alarms do. roll down the window and set the alarm, now open the door and see if it lights off.
2helpful
1answer

How do i enable factory alarm system without keychain remote?

The Simple Act of Locking the Driver side Door WITH KEY Arm the Factory Alarm. And UNLOCKING Same Door with KEY Disarms it The FOB < Rmote for Alarm Just Honks Horn and Flashes Lights, But it Does the SAME ARMIND & DISARMING. I Hope this Helps You out !!
0helpful
1answer

96 jeep grand cherokee. key fob broken... cant start..

Cycle the key in the door lock to disarm a factory alarm.
Not finding what you are looking for?

616 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...