Trouble shooting tells me it is near the heat vent and I don't know where that is located either.
SOURCE: Location of clutch reservoir
The clutch and brake master cylinder share a reservoir. Look below the base of the windshield - the "wall" there is the firewall. You should see a large round piece about 10" in diameter with a metal fixture coming forward off of it. On top of that is a reservoir - that is the clutch and brake reservoir.
SOURCE: Ford explorer xlt front end collision won't start
Could be 2 things. One would be the inertia switch. And the other would be the factory alarm system. Does the "SECURITY" or "THEFT" light flash when the key is turned on?
For the inertia switch, you will need to locate the switch and press the button on top of it to reset it. Good luck, hope this is helpfull.
SOURCE: When I turn on my fan for heat or air, the air
Sounds like a stuck air blend door or a vacuum line on the heater/ac control has come loose.
SOURCE: I have a 2008 gmc acacia. The front and mid
{: ) At the underhood fuseblock, the AUX PWR fuse 20amps is for the Instrument panel and center console outlets, while the RR APO fuse 20amps is for the rear console and rear power outlets.
If your vehicle is equipped with an accessory 110vac, there is this PWR OUTLET fuse 25amps also at the underhood fuseblock. See red arrows on the sample diagram below:
Safety reminders: Use only fuses of the same specifications. A higher fuse rating replacement can heat the wirings and could cause fire.
SOURCE: there is a failure in
If you're getting a code for a heated oxygen sensor circuit problem, replace the sensor. I don't think I've ever seen a fuse be the problem. Bank 1 is located at the back of the engine compartment, close to the firewall. Sensor 2 is the sensor after the catalytic converter.
49 views
Usually answered in minutes!
×