Sounds like its in limp mode what was original problem that caused you to replace the starter? and has anyone been trying to race the vehicle?
SOURCE: honda crv 2000 computer reset
Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps
SOURCE: Trying to access crv starter
Yes looking top view will be hard to work on. I find it easy to get to from under the car and its the best way to work on it. If you going to do it yourself, for the safety, you will need two floor jack stands one for each side which will allow the car to rest ON and able you to lay and work under the car. make sure you set the emergency brakes and disconnect the battery. With this downturn economy, I bet if you post or look on craiglist you might find a mechanic willing to do for cheap. Lots of mechanic are out of jobs and looking for work and needing side work. In your case if you dont want to get dirty; don't have the time or have metric tools, I would find mechanic willing to do it for 50 to 75 bucks. Get a rebuilt starter which will cost half compare to new one. New would run you 140+ and used or rebuilt 50 to 75 bucks saving 75.00 which you can save and use that pay someone to do for you. The total cost would be 140-150 bucks out of your pocket. starter is easy access from the bottom, would take anyone about 30 minutes once the car is up.
SOURCE: MY 2007 HONDA CRV CAR RADIO LOCKED AND IS ASKING FOR CODE
inside glove box there should be a sticker with the radio serial number and code. if that has been removed then you could try the honda owners site. you'll need the vin # and some other info
I was able to get the code recently for my 2010 CR-V
SOURCE: replacing cruise control bulb on honda crv 2006
JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.
SOURCE: How to replace a Honda CRV 2000 thermostat?
Welcome to FixYa.com
Thank you for using FixYa.com, Regards, Lee
Davidian
Remove upper radiator hose
Remove the two 8 mm bolts
See diagram below
130 views
Usually answered in minutes!
×