Use an ohm meter to check the injector and see it is burned out
SOURCE: 99 buick Lesabre
hey thanks for bringing me up to speed. ive been working on many other problems but with your great explanation i remember.
we need to check the compression on that cyl. and compare it to the compression on 2 other cylinders your choice.
but before you do this get a can of carb cleaner . and with the car idling spray around the intake manifold in the area of #6 cyl. what we are looking for is a small vacuum leak that would also act like this. with the engine idling and spraying around the intake the engines idle sould not change and if it does when you spray you have an intake leaking.
let me know how it turns out.
later
paul
SOURCE: engine code p0307 cylinder #7 misfire
It could be carbon deposits on valve seats keeping valves from totally closing. You can try getting you a can of motorcraft PM3 top end engine cleaner and get engine up to operating temp then remove one of the small vacuum lines from the intake and draw the contents of the can slowly into the engine.After you have drawn in the contents shut engine off and let it soak for about 45 minutes then crank it back up and let it run until it clears. Now it will smoke like a forrest fire while you are doing this so don't be alarmed,just tell the neighbors you are spraying for mosqitos.This may cure the problem. If not you may be looking at a valve job.
This can be verified with a compression test if this is what is causing it.
SOURCE: the code reads P 306 misfire on cylinder 6. How
A P0306 code means that the car's computer
has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #6.
Symptoms may include:
the engine may be harder to start
the engine may stumble / stumble, and/or hesitate
other symptoms may also be present
Causes
A code P0306 may mean that one or more of the following has happened:
Faulty spark plug or wire
Faulty coil (pack)
Faulty oxygen sensor(s)
Faulty fuel injector
Burned exhaust valve
Faulty catalytic converter(s)
Running out of fuel
Poor compression
Defective computer
If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.
Testimonial: "Thanks for the ideas"
P0300?? Multiple Cylinder Misfire
P0301?? Cylinder #1 Misfire
P0307?? Cylinder #7 Misfire
are the codes start with the basics inspect plugs wires cap rotor and if all checks out do a compression test
325 views
Usually answered in minutes!
×