SOURCE: 1995 chrysler sebring lxi
there are four 18mm bolts on the opposite side of dust plate.once u remove thoe bolts,you'll have to either use a slide hammer, or the old fashion way a big hammer and smack it side to side.the whole hub and wheel bearing assembly will come out.The dust sheild is in between the hub and axel once it comes apart u will understand.
SOURCE: How Do i Remove Dash Board Speakers From A 1997 Chrysler Sebring
all u do is pop them out, they pull upu may need 2 use a screwdriver or something to get them started, then u follow the wire down and theres a lil connecter u can pull
SOURCE: 2002 chrysler sebring lxi 2dr coupe wont start.
i have same car, same problem was $2 fuse located on top of battery (not beside drivers panel) Hopefully my problem is FIXED FOR GOOD!!!!
SOURCE: How to change an EGR Valve on a 2001 Chrysler
Looking at the engine from the front/top it is in the center between the firewall and the rear of the engine near the throttle input. actually very east to replace.
SOURCE: I have a 2001 Chrysler Sebring LXI Coupe 3.0 mitsu
A great tool to have that can save you some money to read computer error codes and clear them after work has been done can be had for under $100 from Actron. This is what I have been using and its a life saver but it's also good to have the vehicles repair manual as well.
The computer on this car is OBDII like many other vehicles out there these days so you'll need a tool that can plug in and read the outlet located above the shin of your right leg under the dashboard or steering wheel. Here is a link to a bunch of their products on amazon Actron and other OBDII Computer diagnostic code reader tools.
42 views
Usually answered in minutes!
×