2001 Chrysler Sebring Logo

Related Topics:

Posted on Aug 23, 2009

How to change an EGR Valve on a 2001 Chrysler Sebring LXI Coupe

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 10 Answers
  • Posted on Aug 24, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Aug 23, 2009
Answers
10
Questions
1
Helped
3794
Points
23

Looking at the engine from the front/top it is in the center between the firewall and the rear of the engine near the throttle input. actually very east to replace.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2004 Chrysler Sebring Coupe 2.4 litre 4 cylinder engine with 69,000 miles - P0401

P0401 Exhaust Gas Recirculation Flow Insufficient Detected. Remove EGR valve and check for blockage in the passages of the exhaust and intake. If those are clean, replace the EGR valve. EGR valve failure is very common on Chrylsers.
0helpful
1answer

I need a diagram to put on a serpintine belt for a Chrystler Seebring LXI 2 door Coupe

There should be a diagram somewhere under hood. If not, check shop manual (might be able to just look at one a parts store if you feel it is too expensive to buy).
0helpful
1answer

Ok I have a 2001 chrysler sebring lxi coupe with 3.0 mitsubishi engine and just about replaced everything including having transmission rebuilt and now showing code for egr monitoring sensor problem is...

Throwing new parts at a car in response to fault codes in the vague hope it will provide a cure is not the best or the cheapest way to proceed.

Nothing should be replaced unless it can be justified by independent testing. A code reader is not an oracle and the results can be misleading. A fault code is merely the first step of a diagnosis process that is verified or rejected using live data from a scanner, oscilloscope checks, multimeter checks and a deal of experience.

It is often false economy not to pay for a high level of expertise from the start. Paying for skill and experience is often cheaper than a host of unnecessary new parts.
0helpful
2answers

I have changed the timing belt on my 2002 Chrysler Sebring LXI coupe and the car runs great when it stays running. When I shut the car off and start it back up it just starts and dies but if i unhook the...

Check the throttle plates and idle speed control motor make sure there both clean.

Also check manifold vacuum at idle the best you can hold an idle. I have run into timing belt being one tooth off and engine still ran fine. But the vacuum was low that's how I could tell the belt was a tooth off.

3helpful
2answers

Tire specs for 2001 chrysler sebring

HI. Here is the complete line up of specs concerning your vehicles front and rear tires. You did not post the trim line of this car, so I posted all models and tire combination's specified by the manufacture.


2001 Chrysler Sebring Lim 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LX 2 Door Coupe Front and Rear Tires P205/55R16
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/65R15
2001 Chrysler Sebring LX 4 Door Sedan Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Convertible Front and Rear Tires P205/60R16
2001 Chrysler Sebring LXi 2 Door Coupe Front and Rear Tires P215/50R17
2001 Chrysler Sebring LXi 4 Door Sedan Front and Rear Tires P205/60R16
0helpful
1answer

2001 Chrysleraudio Sebring LXi Coupe audio system noise

There is probably a feedback (noise)filter connected somwhere near the coil. the are usually a cylindrical metal filter about the size of a double a battery,usually have a single wire connecting them,there may be one for each ignition coil,the will usually burn the wire when they are bad,not always. hope this helps.
2helpful
2answers

2002 chrysler sebring lxi 2dr coupe wont start. tried jumping it; radio and lights work

i have same car, same problem was $2 fuse located on top of battery (not beside drivers panel) Hopefully my problem is FIXED FOR GOOD!!!!
Not finding what you are looking for?

908 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...