05 pt cruiser won't start cranks and pops but

https://www.google.com/search?q=What+would+cause+the+fuse+warning+light+to+come+on+in+the+odometer+on+05+pt+cruiser.&rlz=1C1CHBF_enUS842US842&oq=What+would+cause+the+fuse+warning+light+to+come+on+in+the+odometer+on+05+pt+cruiser.&aqs=chrome..69i57.3013j0j8&sourceid=chrome&ie=UTF-8

If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves when cranking the engine-if it does not, install a crank sensor.

Are you saying it won't crank, or won't start ?

My PT did that when my timing belt broke. It cost $500.00 to replace it. If it is broken, be ready to have some motor work done. I had to have to values replaced at a cost of $900.00. If your timing belt is not broken then check the alternator and battery. I was riding down the road and my PT shut all the way down and would not start. I had to leave it beside the road. It was my alternator. It gave me no warning.

your crank sensor IS what fires the coil pack
mixing the two years sounds like the problem
check wire harnes see if the 01 powers the 05 the same termail
01 senor and pack may have to go back
good luck!

You shouldn't have any gas smells, maybe a little if the engine were cranking over without starting. But your car is not even cranking, right? Or will it crank and not start? In that case you might smell a little gas, so next step would be to check for spark.

The leak on front passenger side: if that is where the front of the engine is, check carefully your water pump for leaking (then it is bad) and also check all hose connections there for leaks.

Sudden no-start conditions are usually loss of either spark or gas to the cylinders. These are the first things to check when it won't start.

Check for spark and fuel.

Is it a Chrysler 2001 PT Cruiser or a 2004 Chrysler PT Cruiser?

This is because the engine does not accelerate and the RPM falls below the minimum the PCM is in charge of sending a signal for the engine to increase the RPM.Thanks

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?