Questions & Answers for: pt cruiser start crank

...pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or

...PT Cruiser with 77000 miles was doing fine until this last cold snap. First below zero day it started and ran just fine.....second day would not start. cranked slowly then clicking sound. Replaced ...

...pt cruiser won't ignite or crank all lights work even tried jump starting it and it wouldn't even crank How is the oil pressure or low oil. Did the car over heat is so you may have to replace the oil ...

...pt cruiser car died while driving. threw code 320. replaced crank sensor,cam sensor, and coil pack. it still won't start.any suggestions? Check for spark and fuel. Is it a Chrysler 2001 PT Cruiser or ...

...PT Cruiser will not start. When I turn the key there is a "zing" sound. After several attempts it will finally start. Seems to happen more when it's cold. What is the cause? My 2002 PT ...

pt cruiser went dead and now it crank but wont start check your crank position sensor. it might be bad. these also have a problem with the cam position sensors.

pt cruiser will not start until after it sits Pt cruiser will not start sometimes, but will crank aftrer it sits a while Are you saying it won't crank, or won't start ?

...pt cruiser was diving down the road and just shut off will not start If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves when ...

...head on 04 pt cruiser cranks but wont start ignition coil and cam sensors are both new but i have no spark Make sure your cam and crank timing is correct, might have changed when you had the head

...pt cruiser just quite but will turn over will not start put new cam senor and crank senor on it new coil pack and still getting po340 will not start Here's a LONG thread about p0340 codes on PT ...