I would like to see a diagram of where the turn signal flasher is located on a 1994 chevrolet cavalier

SOURCE: locating the turn signal flasher on 1993 corsica

The turn signal flasher is mounted in a clip on the right side of the steering column support bracket. The hazard flasher is located in the component center, under the instrument panel, on the right side. Replace the flasher by unplugging the old one and plugging in the new one.

SOURCE: Directionals Don't work on 99 Cavalier

under the dash below the steering wheel it is probly blue and round located on one of the courners of the fues box

SOURCE: turn signal flasher needs replaced

educated guess..flasher units (2) one for signals the other for emerg flashers usually located in fuse block under dash drivers side kick panel , glove box area ..or engine compartment near battery

SOURCE: 1998 Cavalier rear turn signal doesn't work

The turn signal switches are known to go bad, try to use the turn signal switch and jiggle the lever after clicking to the left turn. Replace signal switch assembly.

SOURCE: diagram on to change turn signal arm on 1994 chevy

1991-94 Cavalier
See Figure 5
This procedure covers removal and installation of the headlamp, headlamp dimmer switch, turn signal and hazard switches, as well as the cruise control switch.

1. If equipped, disable the SIR system. For details, please refer to the procedure located in of this repair guide.

1. If not already done, disconnect the negative battery cable.
2. Unfasten the horn pad, then remove the steering wheel. For details, please refer to the procedure earlier in this section.

1. If equipped, remove the tilt lever from the steering column by grasping the lever firmly and twisting counterclockwise, while pulling it from the column.
2. Remove the upper and lower steering column covers.
3. Remove the dampener assembly, then unfasten and remove the switch assembly from the vehicle.

1. Position and secure the switch assembly.
2. Install the dampener and the upper and lower steering column covers.
3. If equipped, attach the tilt lever to the column.
4. Install the steering wheel, then fasten the horn pad.
5. If equipped, enable the SIR system, as outlined in of this repair guide.
6. Connect the negative battery cable.