Where is the radiator fan relay on 95 oldsmobile aurora

Cooling Fan Relay No. 1
Center rear of engine compartment, left of the windshield wiper motor
7 - COOLING FAN #2 Relay
8 - COOLING FAN #3 Relay High Speed Cooling Fan Relay #3
9 - COOLING FAN Fuse
60A
Cooling Fan Relay #1, Cooling Fan Relay #2

you will need to trace this out with the use of a manual for your vehicle. either look online or go to your local auto parts store to find one. You may get lucky just checking under the hood for fuses and relays. in any case a multi meter will help but the best resource will be a wiring schematic as found in a chilton or hayne's manual.

Its either t

• HOME
• REPAIR HELP
• PRODUCT AND HOW TO INFO
• C
• COOLING FAN SWITCH
• TEST

Cooling Fan Switch ABCDEFGHIJKLMNOPQRSTUVWXYZ Inspect/Test/Replace

To find the RADIATOR COOLING FAN MOTOR RELAY, we need additional information about your 1995 Oldsmobile Aurora 4.0L SFI DOHC 8cyl.
Please select one of the following:

• Number one
• Number three
• Number two

The Radiator Cooling Fan Motor Relay is located: Under hood, passenger side, upper firewall, mounted in corner in relay block
When testing a cooling fan switch, first test it with the engine cold, then test it when the engine reaches a specified temperature. Check your vehicle's service manual for more directions.
To check a switch, disconnect the connector at the switch. with an ohmmeter, check for continuity between the terminals of the switch with the switch moved to the on position and to the off position.

To find the RADIATOR COOLING FAN MOTOR RELAY, we need additional information about your 1995 Oldsmobile Aurora 4.0L SFI DOHC 8cyl.
Please select one of the following:

• Number one
• Number three
• Number two

The Radiator Cooling Fan Motor Relay is located: Under hood, passenger side, front side of wheelwell, mounted in relay panel
The continuity through a switch can be checked with an ohmmeter. With the switch open, there should be infinite resistance. With the switch closed, there should be zero resistance. With the switch off, there should be no continuity between the terminals. With the switch on, there should be good continuity between the terminals. If the switch is activated by something mechanical and doesn't complete the circuit when it should, check the adjustment of the switch. (Some switches are not adjustable.) If the adjustment is correct, replace the switch. Another way to check a switch is to simply bypass it with a jumper wire. If the component works when the switch is jumped, a bad switch is indicated.
Voltage drop across switches should also be checked. Ideally, when the switch is closed there should be no voltage drop. Any voltage drop indicates resistance and the switch should be replaced.
he fan motor,the fan switch,or the coolant temp.sensor.

relays located below center of the instrument panel right front of the console.

Hello natashapaylo: My name is Roger and I will help you. There are 3 different relays that control the coolant fan One is at the center of the firewall of the car. The other two are located inside of the fuse box located under the hood.I will attach a picture of the locations to help. If I can not have both pictures on this email I will send a second follow up answer and attach the second picture to it. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger

Hi!!
Check the Relay Pack located to the left of the radiator (standing in front of the engine) there are 3 relays together, the one closest to the radiator, is the Cooling Fan Relay.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

there should be a fuse located on fuse panel for heater motor( 30 A Green)....after you check fuse other possibilities are bad fan motor...bad heater resistor block.....bad relay...the resistor blocks are very common problems

Will the fan come on if you turn on the AC. This will confirm the fan relay and the computer are ok. If it still does not come on then the problem is not the temp sensor. If the car never gets hot enough the fan will not come on on its own. This would indicate a stuck open thermostat. The temp sensor should be located next to the thermostat housing. Follow the big hose on top of the radiator.

Based on the description, either the problem is on the water pump, the radiator fan or the hoses. If you have replaced the hoses or noticed that the hoses are not brittle and clamps are ok, then you can eliminate it as one of the source of the problem. Inspect the radiator fan if it turns on when you remove the thermostat. The thermostat looks like a small plug that has wires coming out of it and is connected to one of the radiator hoses. If it does not turn on it could be a problem on the relay or the fan itself. You may swap the AC fan relay with the radiator fan. If it still does not turn on then it is a bad fan. If it turns on then, have the relay replaced. Other than that your water pump for the radiator needs replacing. It may not be circulating water correctly.

location of temp sensor for radiator fans on 1995 olds aurora