2002 honda cr v select/reset button broken

Are you talking about the cruise control button? If so, there're 2 screws, maybe torx type. After unscrewed, should be able to remove the controller and replace. Just plug and play...

alot of the computers reset by turning the key to the on position and push in the trip meter holding the trip meter in,turn the key off.... continue holding the trip meter in for about thirty seconds.when you turn the key back on it should be reset

Try this, it works on other Chrysler products.

Insert key and turn to run position. put odometer on the trip position. turn key off.

While holding trip meter reset button in, turn key to run position ( dash lights will be on ) release trip meter reset button and watch the gauge cluster go through a test cycle.

After this cycle the gauges should return back to normal.

Hope this works for you.

1994-99 BUICK LESABRE
CHANGE OIL SOON Light
1. CHANGE OIL SOON light will come on when engine oil has broken down enough to require changing. After changing oil, reset oil life display.
2. To reset light, turn ignition on. Open glove box to access oil reset button. Press and hold oil reset button in glove box for at least 5 seconds, but not longer
than 60 seconds. The CHANGE OIL SOON light will flash 4 times to indicate light has been reset.

Most modern cars have what are commonly called Service Lights. Small lights on the instrument panel can now alert drivers when it is time for service.

Most vehicles do this through a computer calculating how many miles have accumulated since the last service.

However, some vehicles use sensors to gather this data. We have compiled a listing on the procedures to reset the reminder lights on your car, if it is equipped.

If you do not see the reset procedure for your vehicle:Reference the owner's manual that came with your vehicle. Reset procedures are often described in depth with illustrations:

turn the key to the accesories position. pump the break pedal 3 times. the check engin light should flash. then turn the key to the off position and then start the car. the light should reset.


I am not sure if that works I have a 2004 Odysey and I did this and it worked.


While the car is off, push and _hold_ in your Trip meter button, then while still holding that button in... turn your ignition key to _On_ (not start). Wait until light goes out or you need a hair cut... which ever comes 1st. LOL, seriously it should go out in about 15 seconds or less

For a 2007 Honda Odyssey: Turn your ignition to the On position. Press and hold down the trip meter button for ~10 seconds (until the display blinks). Release the trip meter button. Press and hold the trip meter button a second time for ~5 seconds (until the display shows your oil at 100%).

Hope helped.

It is illegal to reset the odometer (total mileage the car has travelled, which is now how the odometer is defined), but if you mean the trip meter:
To reset a trip meter, display it, and then press and hold the Select/Reset knob until the number resets to ‘‘0.0’’.
Hope this helps you.

I get many calls a week for this procedure...
This is really easy! Follow these directions:

Turn the key ON

Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.

Turn the key OFF.

Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.

Turn the key ON

Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.

Release the black trip meter reset stick.

This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.

They must have forgotten to reset the light. If you take a look in the service manual it should tell you how to reset it. With most hondas you simply hold the trip reset button and turn the ignition on. Continue holding the trip reset button until the light turns off.

I get many calls a week for this procedure...
This is really easy! Follow these directions:

Turn the key ON

Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.

Turn the key OFF.

Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.

Turn the key ON, do not start the engine.
Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.

Release the black trip meter reset stick.

This completes the reset procedure, and it will be back on in 5,000 miles, to remind you of you next oil change.