I have a 1995 nissan altima and I need to know the most easiest way to replace the drivers side power window motor/regulator.

Typically a window regulator, it has a lot of plastic parts that can break fairly easily, remove the door panel and while closing the window via the switch pull up on the bottom of the window. and then replace the regulator. if the motor doesn't help you pull up the window check the voltage going to the motor, if you have 10 to 12 volts then replace regulator and motor, if not replace the switch.

I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e

If the power window motor does not work, you would have to disconnect the motor from the window regulator to move the glass up or down.

Should be able to use the same motor, looks like the regulator will cost you a $100.57 from the dealership .
Some vehicles you have to replace everything when a regulator goes out and then the costs mount.

sounds like bad window regulator. could also be window switch,or broken wire between door and body

U MAY HAVE NO OTHER CHOICE THAN TO TRY THE DEALER!

Switch needs to be replaced. Its a common problem and isnt that difficult to replace. Once you get the door panel off, its pretty much unplug the old one and plug those wires into the new one

Dear Kim: From your description, it sounds as though you have a problem with the window regulator and/or motor it self. Nissan and most other manufacturers have now gone "unfortunately" to a cheap design which seem to be very prone to failures. The regulators use a small cable which runs on nylon pulleys and guides. The only point in which the actual force of lift and lowering is applied, is at the center of the regulator and runs on one track. The most common failure is when the cable comes loose because of a pulley or guide failure. The second failure is with the teeth on the motor. The motor and the regulator are available separate. They are not difficult to replace and do not require any special tools. Good luck.....

replace you window motor, or the regulator

Then power window regulator cable is snapped out its place ,you need to install new power window regulator for the door to fix this issue ...


Good luck...