Passenger window works from drivers side. how do i remove the panel that holds the switches?
This could be caused by a couple of different things. First off, when you depress the switch for the driver side window do you hear any kind of noise at all? If you are hearing a noise but it sounds like it's moving very easy, it could be the gear on the motor or the window is off track. If you are not hearing any noise at all, it may be the motor is out and will need to be replaced. These can be purchased from most auto parts store or your local chevrolet dealer parts department. The switch panel typically is held on by screws coming from underneath. You will most likely need to remove the door panel and unscrew the switch panel from the door panel once the door panel is removed from the door. While you have the panel off, you can look inside the door and make sure the motor is plugged in and also test to see if the motor is coming on when the button is depressed or if it is binded up you can hear that also.
Window fuse's and relay's may be up under passenger side dash or behind glove box.
Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes thats all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exsists. Make sure to check for voltage coming to that windows switch. Actually, GM use's a circuit breaker type relay for each window and one fuse for all the circuit breakers.
286 views
Usually answered in minutes!
Passenger window on 95 corvette does not work.Trouble shooting pointed to switch,but ultimately
the ECM(circuit breaker) in the window regulator(motor) was tripping.
After removing the door panel I whacked the motor with a hammer and ECM reset itself.
with the key on push switch in direction that window needs to go and hit door on inside center at bottom of door farly hard . if window moves it is power window motor bad .
×