SOURCE: 94 S-10 Chev Brake problem
This is an easy fix un plug the abs sensor from spindle abs light will come on but the brakes will work only abs will not
SOURCE: brake pedal goes to floor
there is still air in your hydraulic lines somewhere bleed the system with a pressurised power bleeder and you will get instant results
SOURCE: 1998 chevy s10- brake pedal goes to the floor-
Did you put fresh fluid in the master cylinder? I really think you still have air in the lines. To bleed manually, start with the bleeder the greatest distance from the master cylinder, car running, helper pushing down about half way on brake pedal and releasing 3 times, on 3rd time, holding pedal down to half way depressed point while you open the bleeder valve. Repeat until you are sure all air has been flushed out. Check master cyl reservoir level often, because if it gets low and you **** air into the system, you have to start all over again. Go to wheel next greatest distance from master cyl, repeat above, working your way to wheel closest to master cyl last.
SOURCE: Brake Pedal goes to the floor in my 1990 Chevy C1500 Scottsdale
do you have a self bleeder kit? first off, you have to bleed the master cyl back into its self and the combination valve before you go to the wheels. when you do that, I think you will find that you have air in the lines. disconnect both brake lines from the master cyl and put the bleeder kit fittings on the master cyl, then put the rubber tubing with the kit on the fittings and submerge it in the brake reservoir. make sure its full. then pump the pedal until you get a hard pedal. if that is the case, reconnect the lines to the master, then have an assistant pump up the brake pedal with the engine off, and bleed the combination valve which should be connected to the master by steel tubing. pump it up, then hold it down, and crack the fittings loose, one at a time until the pedal goes about half way down, but do not release the brake pedal until the line is tight again, otherwise you will **** air in the lines. after you do all that, go to the farthest caliper or wheel cylynder from the master and bleed that with the same technique,and dont release the pedal until you close the bleeder screw. unless you have a major prob, this will work.
1,251 views
Usually answered in minutes!
×