SOURCE: 97 Astro crankshaft position sensor
HI..
Tha crank position sensor On your astro is located.
On front of the engine on timing cover, left side.
Behind the crankshaft pulley. with a connector of 3 wires.
I hope this work for you.
SOURCE: Where is the crankshaft position
It is stuck in bellhousing of the transmission near the rear head. The new crank sensor will come with a piece of gasket paper on the end of the sensor. Install the sensor all the way in against the pick-up wheel. When you crank the engine the wheel will rip off the paper and the adjustment will be correct.
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: Replace crankshaft position sensor
Remove the left front wheel....(drivers side). Remove all accessory belts. Remove the crankshaft shaft pulley.......remove the plastic lower timing belt cover.....and there it is! It is mounted with one bolt.
The wiring runs down the right side of the timing cover while looking at it from the drivers side of the car.
Testimonial: "I ended up having my mechanic do the work. He did say he had to move all those parts to get to the sensor. "
•
How to test Crankshaft Position CKP Sensor?
---------------
Crankshaft Position Sensor Operation?
----------------
Replace Camshaft position sensor and Crankshaft Position Sensor?
http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
----------
GMC Crankshaft Position (CKP) Sensor
Replacing?
http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html
------------
These details will help.
Thanks.
1,040 views
Usually answered in minutes!
×