Anonymous Posted on Mar 19, 2009

Can't get new axles to seat into trans

I am trying to install new axles in a '99 Daewoo Leganza with an automatic transmission. I have replaced axles on my '90 Honda Civic with manual trans without any problems. I can't get the axles to seat completly into the trans. The Honda and the Deawoo axles both use the same retaining system, so they should go in with a little trial end error and by rotating the shaft until they ''click'' into place, right? Is there a trick to it, or should I just keep cursing at it and do what i am doing? Any suggestions will be appreciated.

1 Answer

Anonymous

Contributor 1 Answer
Posted on Mar 24, 2009

Anonymous

Contributor

Joined: Mar 19, 2009

Answers

Questions

Helped

142

Points

After talking to a Honda mechanic, he suggested thumping with a sledgehammer and a block of wood. It only took a couple of taps and they popped right in! The car runs and feels great.

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

How can I reset the automatic transmission sensors?

No such thing as resetting trans sensors

How do you do drive cycles, if even required
on that trans,you will have to look up that info

That is done by a shop before you get it back,
not by the owner

Read full answer

Sep 26, 2014 • 2001 Daewoo Leganza

0helpful

1answer

HOW DO I TROUBLE SHOOT A 2001 DAEWOO LEGANZA AUTOMATIC TRANSMISSION THAT WILL NOT GO INTO GEAR?

Well, if it is full of fluid, and the shifter is moving the transmission linkage then I would think that there is an internal issue with the transmission.

Read full answer

Sep 26, 2014 • 2001 Daewoo Leganza

0helpful

2answers

2002 daewoo leganza 1st gear OK but wont automatically jump to 2nd n so on as it would do automatically I have to oust the hold button (over-drive) for it to catch gears..why so..plus I'm told by...

need to read codes with a transmission scanner

Read full answer

Oct 17, 2017 • 2002 Daewoo Leganza

1helpful

1answer

Hi, I have read your answer to toping up the GearBox Oil on my, 1998 Daewoo Leganza SX manual transmission, But still cannot find the Filler Hole?

Hi,
The filler hole is on the side of the transmission, you could distinguish the hole by the screw plug.
The screw plug is sometimes a square screw or a square hole, it's near the left side axle shaft.
Hope that helped you out!

Read full answer

Sep 13, 2011 • 2000 Daewoo Leganza

0helpful

1answer

G/day i need help puting in a new clutch kit into a 99 leganza the car is off the ground wheel is off now do we start by taking off/or dropping the passenger side suspension and all so the plastic covers...

It's best if you get a manual on this. Some times it is easier to remove the engine and transmission. some times you can remove enough of the steering and wheel parts to spread the trans and engine apart to get a clutch package out and in. these are always a look and see type job. They are difficult to do, not impossible. You also have to remove both drive shafts, so both sides have to come apart as you have stated.

Read full answer

Apr 23, 2011 • Daewoo Leganza Cars & Trucks

0helpful

1answer

Daewoo Langanza 1999 Once car warms up on take off there is a loss of power. I have a automatic transmission. On take off the tac will go to the red while at 15 mi an hr. on speedometer. I have been...

You have trans slippage. Check fluid level and condition. Your trans is probably fried.

Read full answer

Jan 03, 2018 • 1999 Daewoo Leganza

2helpful

1answer

I have a 01 daewoo leganza where is the drain plug for the automatic transaxle/transmisson to drain the fluid and replace it?

I have a 2000 Leganza. It was far easier to drain the fluid with a suction hose fed down the transmission filler pipe. Less messy too! You also have the benefit of knowing exactly how much you took out and can avoid overfilling it with the fresh fluid.

Read full answer

Jan 18, 2011 • 2001 Daewoo Leganza

2helpful

1answer

Is the Daewoo Leganza and the Nubura 2Ltr Engine the same?

the 2 engines arent the same...the trans will not fit the engine either....harness and ecu are different as well..i wont go into detail except to say to not bother wasteing ur money on the wrong engine...keep searching u will find the right engine evntually...

Read full answer

Apr 11, 2009 • 1999 Daewoo Leganza

0helpful

1answer

Daewoo Leganza 2001 4 cyl/gas CDX. Coolant leak/into transmission ZF4HP14 model type.Difficult to find parts in my aerea.Can u recommend me a compatibale engine/transmission or only transmission GM /other...

if it still pulls good its ok but your cooler in the radiator has come apart so you need to buy an aftermarket trans cooler and flush the tranny and refill with new fluid

Read full answer

Mar 31, 2009 • 2001 Daewoo Leganza

2helpful

2answers

ECU port for 99 Daewoo Leganza

you mean the diagnostic port? All vehicles after 1996 use obdII and the rules for the location of the plug state that it must be accessable from the drivers seat. it could be anywhere from near the drivers door to the center console. It may be covered by a plate. get a good flashlight and good luck. You can also contact Daewoo at www.daewoous.com or call 1-800-323-9668

Read full answer

May 15, 2008 • 1999 Daewoo Leganza

Not finding what you are looking for?

View Most Popular

1999 Leganza

Cars & Trucks

How can I reset the automatic transmission sensors?

2001 Daewoo Leganza

152 views

Ask a Question

Usually answered in minutes!

Check Out the Latest Top Trucks Report!

View all Fixya Reports

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for 1999 Daewoo Leganza? Or just drag it here!

Related Topics:

Can't get new axles to seat into trans