Question about Dodge Grand Caravan

Open Question

Engine code P0301 dodge grand caravan 07 - Grand Caravan Dodge Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2006 Dodge Grand Caravan - EGR code

I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.

Posted on Oct 06, 2008

SOURCE: Dodge 2005 Grand Caravan water Pump replacement

JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.

GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.

Posted on Apr 29, 2009

  • 14036 Answers

SOURCE: 2005 dodge grand caravan getting code p0406

3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

Posted on Jul 04, 2009

  • 7 Answers

SOURCE: 2005 dodge caravan engine light code p 441

If you mean code P0441 - This Relates to Incorrect Purge Flow for Evaporative Emission System

Posted on Aug 16, 2009

  • 149 Answers

SOURCE: What is E 400.1 on 2003 Dodge Grand Caravan?

EGR valve failure

Posted on Jan 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Misfire on #5 cyl


2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers
Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305
A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan
Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An


Dec 05, 2015 | 2005 Dodge Grand Caravan

1 Answer

07 grand caravan sounds like a rod knocking, but look at them & no sign of worn out bearing.


Without actually hearing the noise, it is hard to help. You can try starting the engine and disconnecting one plug wire at a time to see if the noise diminishes when the plug wire is disconnected and this will help isolate the cylinder causing the noise and then diagnose from there.

Jul 12, 2015 | 2007 Dodge Grand Caravan SXT Minivan

1 Answer

What is the firing order for 2006 grand caravan 6 cyl


Hi , could you supply the correct engine code and vin number ?
For the engine code (EKG) the firing order is 1-6-5-4-3-2
For the engine code (EGH) the firing order is 1-2-3-4-5-6

Jun 07, 2014 | 2006 Dodge Grand Caravan

1 Answer

2002 dodge caravan engin code P030.1


P0301 Cylinder #1 misfire. First of all check Spark plug, plug wire, Compression in #1 cylinder and if all are fine then I would be looking at the fuel pump !

Jan 11, 2013 | 2002 Dodge Caravan

1 Answer

2005 3.8 dodge grand caravan engine rough idle and mainly while running on road under a load or up a hill. Had engine light checked out gave a P0301 -#1 cylinder misfire replaced plugs and wires and still...


did you check the coil it may be bad. for # 1 cylinder. if you can, just replace them all. then you will know everything is ok! but change #1 coil first to find out. try putting some injector cleaner in the tank, or swapping the injector from the #1 cylinder to the #2 and see if the code follows it and let us know.

Aug 26, 2011 | 2005 Dodge Grand Caravan

1 Answer

2005 Dodge Grand Caravan. Code check


Cycle the key on, off, on, off. on. Then count the flashes 12 is normal 55 is end of sequence

Feb 06, 2010 | 2006 Dodge Grand Caravan

1 Answer

My 96 Dodge Caravan ES with 127736 miles has the check engine light on with code P0300 and P0301. The plugs, wires and ignition coil have been replaced more that once. Still getting the codes. What could...


Hi there, the problem could also lie with the fuel injectors / fuel pressure, burned valves, exhaust restriction, etc. Lots of things, for a more detailed list see http://www.obd-codes.com/p0300

Jan 31, 2010 | 1996 Dodge Caravan

1 Answer

2005 dodge grand caravan getting code p0406


3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .

Jul 04, 2009 | 2005 Dodge Grand Caravan

1 Answer

2005 Dodge Grand Caravan. Check engine light on displaying PO0406 any ideas? Code came up by cycling key on and off 3 times.


the PO406 code is the EGR position sensor.
I have heard tho that DMX corp had some issues with this code in the past where basically it was just tossing false codes. But they also did have a higher fail rate on them during 05-07, so you may have to replace it anyways.

Jun 28, 2009 | 2005 Dodge Grand Caravan

1 Answer

My 1998 Dodge Caravan is giving me ses codes 300 301


P0300 is a multicylinder misfire code and p0301 is a cylinder no. 3 msfire code. Check your spark plugs and plug wires.

Apr 03, 2009 | 1998 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...