Removing seat cushion of toyota yaris 2012 model

Step 1

Slide the two front seats forward. This may not be necessary, but it will give you more room to work.


Step 2

Pull the seatbelts out of the slits at the back of the cushion. You are not removing the seat belts, just moving them out of the way.


Step 3

Remove the mounting bolt from the rear seat cushion with a socket wrench. You will have to lift up the front edge of the cushion to get at this bolt. Then, pull the cushion up and out of the Camry.


Step 4

Locate the seat back locks and undo them by pulling them up.


Step 5

Move the seat backs down and remove the mounting bolts with a socket wrench. These bolts will be located at the center hinges.

Pull the seat back up and out of the Camry.

Certain models only

Under the dash on drivers side, follow the link for a video. Interior Fuse Box Location 2012 2016 Toyota Yaris 2012 Toyota Yaris 1 5L 4...

You're talking about the back seat. I had a toyota once that you pushed bottom cushion toward back of car, and then lifted up on front of cushion. Probably some trick like that but you might try google for that model of car also.

replace firmware and.or replace data fuse Interior Fuse Box Location 2012 2014 Toyota Yaris 2012 Toyota Yaris 1 5L 4...

You must remove the seat cushion first, there are buttons under the seat cushion that you push in while pulling up, one on each side, then just unbolt the backrest unhinge from package tray and remove.

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

Hello, and welcome to FixYa. Please let us assist you.

To remove the rear seat back, you first have to remove the rear seat bottom cushion. There are two clips on the front edge of the cushion, and they need to be disengaged; pull up with some force on the front edge of the cushion, where it meets the floor. Once the clips are disengaged, you can take the bottom cushion out of the car. Next, you will see the bolts that holds the rear seat backs onto the rear metal pane; all you now need to do is remove the bolts, and slide the seat backs up and out.

Thanks for choosing FixYa for advice today.

on the front hinges ther are two spring clips use long nose pliers to remove and slide out pin.put on cover and REPLACE pins/clips.(spring clips look like washers)

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).