At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
HI , JUST WANT TO ASK HOW COULD I REMOVE THE REAR SEAT CUSHION OF MY TOYOTA YARIS 2007.I WANT TO INSTALL A SEAT COVER SO I NEED TO KNOW HOW TO REMOVE THE REAR CUSHION...PLEASE HELP//THANKS A LOT.
First check the manual. Some airbags are built into the seats and in that case, seat covers are a no-no since they would interfere with proper airbag operation.First check the manual. Some airbags are built into the seats and in that case, seat covers are a no-no since they would interfere with proper airbag operation.
You can't post conmments that contain an email address.
On the front hinges ther are two spring clips use long nose pliers to remove and slide out pin.put on cover and REPLACE pins/clips.(spring clips look like washers)
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Slide the two front seats forward. This may not be necessary, but it will give you more room to work.
Step 2
Pull the seatbelts out of the slits at the back of the cushion. You are not removing the seat belts, just moving them out of the way.
Step 3
Remove the mounting bolt from the rear seat cushion with a socket wrench. You will have to lift up the front edge of the cushion to get at this bolt. Then, pull the cushion up and out of the Camry.
Step 4
Locate the seat back locks and undo them by pulling them up.
Step 5
Move the seat backs down and remove the mounting bolts with a socket wrench. These bolts will be located at the center hinges.
well of you can see the end, pulling seat sound like it.
or if there are no plastic covers with screws, yes.
the FSM covers this.
read it.
alldata.com might have this under body chapter
Hi! Chances are the clip that holds the rod on the lock has broken, the only thing left to do is to remove the rear lower seat cushion first and then the upper cushion if its not a fold down seat, and reach for the emergency latch inside the trunk. Good luck!
please check below the rear seat you can see small plastic cover have fitted near seat it's same color of your interior carefully remove that plastic covers without braking locks then you can see bolt for remove rear seat cushion remove bolts and slide the cushion towards front.
Hello, and welcome to FixYa. Please let us assist you.
To remove the rear seat back, you first have to remove the rear seat bottom cushion. There are two clips on the front edge of the cushion, and they need to be disengaged; pull up with some force on the front edge of the cushion, where it meets the floor. Once the clips are disengaged, you can take the bottom cushion out of the car. Next, you will see the bolts that holds the rear seat backs onto the rear metal pane; all you now need to do is remove the bolts, and slide the seat backs up and out.
OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).
First check the manual. Some airbags are built into the seats and in that case, seat covers are a no-no since they would interfere with proper airbag operation.
×