Location of fuse for radio on the 2001 acura cl type s coupe

SOURCE: transmission dipstick location

Sorry, I'm just now getting it to you.  The dipstick is located on the passenger side of the car way down at the bottom.  It should have a yellow handle.  It's just to the right and down of the battery.  Let me know if you can't find it still and I will get you a picture somehow.

SOURCE: 2003 Acura CL Type S Radio Code

I have a 2001 Acura 3.2 CL

Turn your radio off
Press the #1 Preset button and #6 Preset button at the same time and while doing this with your other hand turn your radio on and your will get a stereo code. Call the dealer and see if they will give you the unlock code for the stereo code otherwise go to stereo-code.com and pay $ 28.00 to get it quick

Marvin

• 85242 Answers
• Posted on Aug 06, 2009

SOURCE: Where is the cabin af in a 2001 Acura CL 3.2

You open the glove box and you will see two black plastic pieces toward the top on either side of the glove box. This is what is holding the glove box up. Get a screw drive and pop these off. the glove box will fall down. Then you will see a white plastic box this is where your filters are...open it and pull both out and replace

Greg Bernett

• 2993 Answers
• Posted on Nov 03, 2009

SOURCE: how to locate the thermostat for a 1997 acura 2.2

Removal & Installation

1. Disconnect the negative battery cable.
   
2. Drain the cooling system into a suitable container.
   
3. Locate the thermostat housing by following the upper radiator hose to the engine.
   
4. Loosen the hose clamps then carefully detach the hose from the fitting.
   

1. Disconnect any sensors or switches that may interfere with the removal of the thermostat from the housing.
   

1. Unfasten the retainers, then remove the thermostat housing.
   

1. Remove the thermostat carefully noting how it's installed.
   
2. Clean the mating surfaces of the thermostat housing.
   

1. Install the new thermostat and gasket.
   

1. Install the thermostat housing, then tighten the bolts securely.
   
2. Connect the radiator hose and tighten the hose clamps securely.
   
3. Install any remaining components, then refill the cooling system.
   
4. Start and run the engine until it reaches normal operating temperature while checking for leaks.
   

Testimonial: "thank you very much on the solution, didn't take as long as i expected!"