It start but doesnt go into 1st, 2nd, 3rd, 5th, or revese gear it only runs on 4th gear
The
following are the general instructions on the start of diagnosing any
electronically controlled engine or transmission problem. The
engine and the automatic transmission (transmission control is only
for automatics, engine is still computer controlled no matter the
transmission type) in this vehicle are computer controlled and in
most cases when a fault occurs a fault code is stored in the memory
of the computer control module. There are exception to this, such as
the Mass Airflow Meter and fuel pressure problems. What must be done
is to have all the basic testing done such as a scan of the system
for fault codes as well as a check with a live data scanner tool for
engine functions that are not within range of normal, a trained
technician is required to know what is correct and what isn't, then
based on careful diagnostics done from a factory repair manual the
correct part is replaced or the wiring repaired or the computer
replaced (known as the PCM), which is very rarely the problem. Other
basic checks must be done as well such as mechanical problems with
the engine as well as engine state of tune and mileage on the engine.
The transmission can have mechanical issues as well such as no gear
engagement at all or a failed pump or other pressure related
problems. Also engine mechanical problems ca cause many
drive-ability related problem such as rough idle and other symptoms
SOURCE: I only have 3rd and 4th gear, 1st 2nd and 5th are
Purchase a gear shift repair kit for your car. They are pretty cheap. About 20 bucs. The ball and bushings are probably worn.
SOURCE: Only 3rd and 4th gears available - 1998 jetta
im not telling you what to do because it could be a bad transmission and an easy fix but I cant tell without looking at it , but if its a hard fix just go to a reliable junkyard and get another
SOURCE: what is the function of 1st,2nd,3rd,4th,5th gear?
the function of the gears are to transfer and convert energy created by the engine into momentum
SOURCE: my ford focus tdi 2003 cant select 1st,3rd or 5th gears.
Car is in limp in mode unless you have the tools to work on automatic transmission you will need to take it to a transmission shop. Of course you can check oil level but I suspect you have other issues.
64 views
Usually answered in minutes!
×