Im trying to find out the location of the fuel filter on a 2000 cadillac eldorado
SOURCE: fuel filter
the fuel filter is on the passenger side in front of the gas tank under the door basically cover by a plate with two bolts in it
SOURCE: trying to find location of fuel filter on a 2005 cavalier
On my 2003 Cavalier the fuel filter is located towards the drivers side right ubove and slightly to the front of the rear axle. I can get you some pics if you like. Thanks
SOURCE: O2 Sensor on a 1996 Cadillac Eldorado
Hello mrsalbert, my name is JShreader. Thank you for choosing fixya.com
Depending on which oxygen sensor you are looking for...there are several of them throughout the Exhaust System. I will start out by giving you a brief description of what and oxygen sensor is, and they're general purpose.
DESCRIPTION
Four Heated Oxygen Sensors (HO2S) are
mounted in the exhaust system where they monitor the oxygen content in
the exhaust stream. There is an oxygen sensor mounted in each exhaust
manifold and one on each end of the catalytic converter. the oxygen
sensor located in the front exhaust manifold is the Bank 2 Sensor 1
(Front) sensor. The oxygen sensor located in the rear exhaust manifold
is the Bank 1 Sensor 1 (Rear) sensor. The oxygen sensor located in the
Y-pipe ahead of the catalytic converter is the Bank 1 Sensor 2
(Pre-converter) sensor. The oxygen sensor located in the catalytic
converter outlet is the Bank 1 Sensor 3 (Post-converter) sensor.
OPERATION
An oxygen sensor acts like a battery because it creates its own signal
voltage once it reaches operating temperature. This voltage is produced
when the oxygen content in the exhaust stream is different than the
oxygen content in the atmosphere. A lean condition (high oxygen content
in exhaust) will produce a low voltage (near 0 volts) and a rich
condition (low oxygen content in exhaust) will produce a high voltage
(near one volt). The PCM provides a reference signal voltage (0.45
volt) and a ground to the sensor. The PCM reference voltage is
necessary because the oxygen sensors do not provide their own voltage
until they reach operating temperature.
HEATING ELEMENT
the oxygen sensors also incorporate a heating element inside of the
sensor housing. This heating element is energized with the ignition On
and allows the sensors to reach operating temperatures quickly. The PCM
can then use oxygen sensor information sooner after engine start-up.
PCM INPUTS
The PCM uses oxygen sensor information during Closed Loop operation to
constantly adjust fuel control to reduce exhaust emissions. Because the
oxygen sensors provide information sooner after engine start-up,
exhaust emissions are reduced. Faulty oxygen sensors will cause various
driveability conditions and will set a DTC.
That being said...I uploaded a .pdf for you of pictures showing the locations of ALL the oxygen Sensors on your Vehicle. You can download it by clicking HERE.
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!
SOURCE: fuel filter replacement
the fuel filter is located on the drivers side under neath where the rear seat would be connected to the frame. relieve fuel system pressure,disconnect negative terminal from the battery,raise rear of vehicleand support it securily on jackstands,detach fuel lines from the filter,some have quick connect . squeeze plastic tabs to pull the connector apart,if it has threaded fiting unscrew the fuel line from the filter.
SOURCE: location of fuel filter 2000 prerunner 2.7 engine
In the engine bay, on the firewall, behind the engine if it's a 2.7L I4. It'll be tricky to change due to space constraints.
213 views
Usually answered in minutes!
×