I have the clutch kit & just need more specifics about the how to's, especially tricks & tips
After the nuts and bolts are out your kit should have a allinement tool for pressure plate and cluch disk did kit come with throw-out and pilot bearing would be a good time to change them
If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352
SOURCE: removing/replacing a 2000 kia sportage 4x4 4 dr heater core
The heater is located under the dash board to the right and down from the radio. To remove and replace it you will have to remove the dash board down to the fire wall. Also, you will have to disconnect two hoses that connect up to it from the engine compartment. These are located in the back of the engine and down on the firewall about midway. Once you remove the dash board and locate the heater core you will be able to see the location of these two hoses. Removing the heater core is time consuming but it will save you about 700 dollars.
SOURCE: need diagram for timing belt replacement on 2001 kia sportage
You can get a haynes manual on timing belts from your local motor store or Halfords.
SOURCE: 2002 KIA Sportage 4x4. 4x4 not working
Is the four wheel drive activated by vacuum? Check vacuum.
SOURCE: timing belt diagram 1997 kia sportage 4x4
My scanner isnt working, so i hope this can help you out some...On the left Camshaft..you will a stamp I and E...iI is for intake and E is for exhaust..The I should be up at 12 o'clock and the E should be at 4..you will also have marks on the timing plate behind the camshafts to help you line it up right...Now on the Right Camshaft you will have the same marks, but this time you want the E at 12 and the I at 7 o'clock..And the crankshaft should have a little notch on it, where you can line that up at 12 o'clock with the notch imprint that is on the plate for you..You may have to clean those areas, and use a light, so you can see them..I hope this helps you out..Goodluck...
1,190 views
Usually answered in minutes!
×