Not working port to scan

No. Obd 2 is data based. Most auto chains have scan tools and will pull codes for free. Basic scan tools can be purchased for around $50 to 100

You have an internal transmission problem . you need to scan the PCM to pull the code and pinpoint what is causing the transmission to set the light.

The O2 sensors are mounted in the exhaust pipe before and after the catalytic converter if that is your question.

have a scan run,could be a sensor.

Your front ABS sensors are bad.

Possible you have a vaccum leak or blockage.The direction of flow for heat and air is controlled by way of vaccum lines.

This has to do with your bank one O2 sensor. You may just need to clean it off, possible you may have to replace it.

call local junk yard those guys know the answer

take the car to advance auto parts they can scan the codes and tell you right there what they mean

The codes are lean fuel condition for both banks. A very common problem with this engine that will set these codes are the upper & lower intake gaskets. You may experience a rough or rolling idle at cold start up and the condition will go away as the engine warms up. If you have checked all the basics such as vacuum leaks or air inlet leaks between the air filter box and the throttle body, then I would consider replacing these intake gaskets. Good Luck and please leave rating. Thanks