1993 Dodge Dynasty Logo
Posted on Nov 15, 2008

No brake lights of blinkers 1990 dodge dynasty



1990 dodge dynasty no blinkers, emergency flashers brake lights.
checked all fuses when car alarm is activated the flashers will flash.

  • Anonymous Mar 28, 2014

    headlights - emergency flashers - taillights - blinkers - dash cluster

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 1 Answer
  • Posted on Dec 29, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jul 03, 2008
Answers
1
Questions
3
Helped
560
Points
1

While not likely, it is possible that the light bulbs in both sides are have bad filaments. Turn on ignition key (but don't start engine). Then turn on parking lamps (first detent or "click" on headlamp switch). Walk around car and look for illumination on front parking lamps and rear tail lights. Turn on the right turn signal. Are those (right hand) lamps now changing brilliance? Try the left turn signal in the same manner. Are those (left hand) front and rear lights changing briiliance? Take note of any positions that did NOT change briliance when the turn signals were activated. If NONE changed briliance, you either have a bunch of bad bulbs (unlikely) or a bad flasher (more likely) or a bad turn signal switch (most likely) or perhaps wiring problems (possible if the car has been in a collision or has been "worked on" by some "non-expert" mechanic). Check the action of the emergency flasher control switch located on the steering column (facing up). Pushing it in (down) should result in the button going to two different heights alternately (low, high, low, high). You could just have bad flashers or corroded flasher contacts! Good luck!

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

1990 f150 straight 6 it's happened before, blinkers not wrkg and rear lights. replaced blinker switch last time

If your brake lights are working, then the wiring to the turn signals are good. Check the turn signal flasher which is under the dash. Try your emergency flashers. Do they work?
0helpful
1answer

Brake lights not working

check brake pedal switch for conductance and check all fuses again. I unhooked trailer once and blew out a fuse that was independent of the brake light... If you have blinkers working it narrows it down. Check emergency flashers to see if thats working.
0helpful
1answer

Need a diagram for how to find the flasher in a 1999 dodge stratus..it's not in the fuse boxes

Simple method without mystery:
  1. Turn blinker flashers on;
  2. Listen for clicking;
  3. Find source of clicking. It is the flasher. :)
NOTE: Emergency flashers and blinkers usually use a separate flasher unit, but one is close to the other. If your blinkers do not work but your emergency flashers do, find the emergency flasher unit by finding the source of clicking, then locate the blinker flasher nearby. They will ALWAYS be underneath the dashboard on the driver side.
0helpful
1answer

1998 dodge durango, when I turn the key on, or to the lock position, the flasher fuse relay on the driver side makes a loud buzzing sound. I replaced the fuse relay and checked all the fuses. Any ideas on...

IM NOT SURE.
BUT fix the emergency flasher failure
first using the logic, gee you see its busted,why on fix that and pray.
military doctrine does that too, and then says if 2 things wrong fix the simple one first. (getting lucky save time and dead solders)
10x that if related, and is. ! IMO
noise here,and bad emerg.. kind if same area.
the issue with the emerg. flasher is the contacts can mangle inside
and confuse related circuits. flashers, and warning modules.
2helpful
2answers

Blinker lights not working on my dodge ram 1500 1996. Emergency lights work fine and fuse isn't the problem. No arrows turn on when turning the blinkers on but the emergency lights are working fine. Can...

I bet your blinker flasher is not working. Most likely it uses two flashers, my Intrepid did. Somewhere (probably near the fuse box) and likely under the dash you will see a board with relays and stuff plugged in. You will also see two round things, those are most likely the flashers. Swap them if they are the same, then your hazard lights won't but your blinkers will, at least until you get to the store to get a replacement.
0helpful
1answer

What can cause blinkers not to flash after relay switch has been replaced

Check your emergency flasher knob,and make sure it is not engaged.Check all fuses and bulbs.And replace then emergency flasher also.
0helpful
2answers

1988 dodge dynasty blinkers won't work at all

If u here it ticking it means the flicker unit is responding so check the fuses and ground wire
0helpful
1answer

1989 chevy 1/2 ton.brake lights or emergency flashers dont work.tail lights an blinkers work.

The Blinkers and the Brake Lights are the same bulb. So check the brake light switch. Flashers use a different flasher unit, than the turn signals
2helpful
1answer

Anti theft alarm won't shut off

Lock all doors..Then with the key unlock passengers side door then it should stop..

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Not finding what you are looking for?

570 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...