Have no power to fuel pump
SOURCE: fuel pump relay location
dfifrank: The relay you are seeking is locate on the driver's side of the car. The left kick panel or panel forward of the left front door pillar. There is a large box which is the ABS control unit.
There are two smaller relays with it. The relay mounted which is closest to the rear of the car is the fuel pump relay.
The relays in the fuse panel are as follows: the one to the extreme left which is located half way up the box is the ignition relay.
The one at the top right is the accessory relay and the one at the bottom right is the blower relay.
You have a pair of audio amp relay's located in the right lower kick panel and a flasher unit sometimes referred to as a relay, located further up closer to the firewall on the right kick panel.
I believe this should answer your questions and then some.
I service a lot of Maxima's consequently they are somewhat familiar to me.
SOURCE: 2004 nissan altima fuel pump relay slot ID
check your crank angle sensor first. it may be faulty. the pump is not gonna run, if there is no crank signal, from the sensor. nissan has problem with those.
SOURCE: WHERE IS THE CAM POSITION SENSOR LOCATED ON A 2004 NISSAN MAXIMA
WHEN YOU STAND ON THE FRONT OF THE CAR YOU ONE IS RIGHT BELOW OF THE INTAKE WHICH IS BANK 2 OR THE ONE CLOSE TO FIREWALL , BANK 1 ONE IS ON SAME SIDE NEXT TO THE RADIATOR BUT THEY BOTH ON THE CAM RIGHT SIDE OF THE ENGINE, THE EASIEST WAY TO IDENTIFY THEM IS THAT THEIR CONNECTOR IS GREEN, ONCE YOU LOCATE THEM THE CLIP NEEDS TO BE PUSHED DOWN TOWARD THE SENSOR FOR THE CONNECTOR TO BE RELEASED, ONCE YOU REMOVE THE CONNECTOR THERE WILL BE ONLY A 10MM SCREW HOLDING THE SENSOR PULL IT OUT , THE SAME SETTING THE NEW ONE PUSH IT ALL THE WAY IN , THIGHT THE 10MM SCREW, CONNECT IT BACK AND YOU'RE DONE,BUT FOR THE ONE ON THE BACK SOMETIMES MIGHT BE NECESARY FOR YOU TO TAKE THE INTAKE OFF....HOPEFULLY IS NOT YOUR CASE....
Good luck!!! and if you need the crank for hard starting on hot/warm, it is located on the botton middle section on the transmission is the only cable that goes down to a small piece of metal and it is held by a 10mm screw only to protect the sensor, you will se the sensor once you remove that small about 6-8 inches piece of metal. Then you'll be able to unescrew the 10mm screw that holds the crank position sensor. when you pull it off you'll be able to see the fly wheel inside the transmission...
you all enjoy your rides out htere!!!
SOURCE: fuel problem
I had the same problem with my 99 Subaru Forester and it was caused by oil leaking and getting into the spark plugs. We only needed to remove & clean one of the plugs and then we were running smoothly again. Very well could not be what your problem is but it's worth a shot mentioning.
SOURCE: locate fuel filter on 2007 nissan sentra 2.0 liter engine
its in the gas tank but it doesnt have to be changed!!!YAY
2,302 views
Usually answered in minutes!
×