Oil sending unit location
SOURCE: Location of the Oil Pressure Sending Unit
On the drivers front of engine block below the cylinder head & gasket . Slightly behind waterpump.
SOURCE: exact location of oil sending unit on a 95 ford
on OHV engine,at rear of engine block,just ahead of transaxle
on OHC on forward side above oil filter.
SOURCE: where is the oil sending unit on a 1996 ford
On 3.0L OHV engines, the oil pressure sensor is located on the left
side of the engine block above the flywheel. On 3.0L DOHC engines the
sensor is located on the left side of the engine block above the oil
filter. On 3.4L DOHC engines the sensor is screwed into the oil filter
adapter. The oil pressure sensor operates the oil pressure warning lamp.
Fig. 1: Location of the oil pressure sensor-3.0L OHV engines
Fig. 2: Location of the oil pressure sensor-3.0L DOHC engines
Fig. 3. The oil pressure sensor-3.0L OHV engine
Hope help with this (remember rated this help). Good luck.
SOURCE: location of oil sending unit
its on the rear of the block, driver side, about halfway up --- behind and practically entangled with the harness.
A better question: How do you remove the connector?
SOURCE: where is the oil sending unit on a 2001 ford
hi the only problem driving it is not knowing ? its located on the front surface of the drivers side cylinder head near/next to oil filter hope this helps if so please rate it
286 views
Usually answered in minutes!
×