20 Most Recent 2011 Audi A3 Questions & Answers

the dash fuel gauge should be ok if the dash computer fuel reading cant be reset ring or pop into an audi service centre to ask advice at worst re new or re calibrate fuel tank sender and float

Has to be a connection issue, and with fuse boxes, many will have contact issues if moiture gets into fuse box. Look for fuse connector corrosion for your fuse for lights, which usually are marked in your fuse box cover or manual. Once you know which fuse is for your headlights and tailights, look for a white residue on connector, sure sign of corrosion, then simply clean with contact cleaner, or take small brush or tooth brush and clean contacts, then scratch surface with small screw driver and plug back fuse, of course, assuming fuse is not broken or defective. It is rare to have fuses be the problem with intermitent connection problems, but not impossible. Good luck,

not on this website sunshine,this is mainly for the USA.and informs people on how to repair faulty cars.not supply parts costs.

Question edited for clarity. Question moved to model category. Check out the videos, and also already answered on Fixya https://www.fixya.com/cars/t6734476-crank_sensor https://www.google.com/search?q=2008+audi+A3+2.0+tdi.+crankshaft+sensor+location ..

NO THE PROBABLE CAUSE IS A VALVE THAT ADJUSTS THE TURBO PRESSURE!CHECK FOR DTCS FIRST AND LET ME KNOW!!

The following asumes only one wheel is hot and the e-brake is not engaged or possibly hung up from having been left on while the car was not driven for a while. Up north, BMW (Audi ?) brake disks tend to start rusting after about a week of inactivity. For a hung up e-brake, it is sometimes necessary to go back and forth to break the corrosion. A hot wheel usually indicates that the brake pad is dragging (i.e. the brake caliper piston is not returning into the brake caliper bore). A couple of checks: measure the brake disk temperature with a temperature gun on both brake disks of the same axle. If one is much higher, the caliper piston is probably sticking. Can also check for relatively large temperature difference with your hand-just do not touch the metal or you will get burned. Look at the brake disk for evidence of the outline of the brake pad that may have transferred to it indicating a very hot brake disk. Chock the car well, put into neutral with e-brake off, jack up "hot wheel" side and try to spin the tire. If a lot of drag, sticking caliper piston. Caliper replacement or disassembly for a thorough cleaning will probably be required. If this is necessary, you should do both brake disks and pads and consider doing both calipers on that axle depending on age and corrosion condition.

If you have replaced 4 sensors the problem must be somewhere else in the system. Exactly which sensor is it as there are many sensors built into an engine and transmission? You could get a Good Auto electrician to check the vehicle to see if there is another cause of the problem.

crank sensor fault

It could be a few different things.
Did the check engine light come on before it quit running?

Most likely the disc player has a failed loading system, very common, pull it out and have it rebuilt.

No injector relay in this car. Injector pulse is controlled directly from ECU.

200 RPM are you sure?

On this website, you find fuse box diagram for Audi A3 (1996 - 2003) Audi A3 8L 1996 2003 fuse box diagram Auto Genius

You can check this website maybe it helps you, you find there fuse box for Audi A3 https://www.autogenius.info/category/audi/a3