Questions & Answers for: Chevrolet voltage issue

...voltage issue here. i would preform a voltage test. there should be 14 volts going to the pump. if its lower than 14 volts, this will be the issue. weak pump flow. also, there may be some trapped air ...

...are fine. What am I missing? Check All Engine and Chassis Grounds!Grounding Issues cause most Low voltage or No voltage

...reset stop screw? I believe that has been the problem all along. WHEN YOU MOVE SCREW YOU CHANGE TPS VOLTAGE READINGS YOU WILL NEED TO MONITOR TPS VOLTAGE AND ADJUST BACK TO SPECS DONT KNOW EXACT BUT ...

...issue? I thought it could be the starter so I changed it, still have the same problem. Do you know how to test a starter electrical circuit ? How to voltage drop test starter motor circuit Starter ...

...issue. I tested voltage on everythin in the sockets and the wiring harnesses for each light and the main wiring harness tha fuse is good, bulbs are good. has to be a wiring issue my guess is a short. ...

...issue. replaced starter as it was factory original, truck ran great three days, acted like starter failed again, replaced starter a second time, cranked and ran three or four times, now acting like ...

...to get the codes read this will give you lots of information and insight into witch sensor is causeing the issue . But is no voltage sensor .Voltage regulator or alt or battery these supply all ...

in the steering coulum I would get the alternator checked to make sure it has good voltage. It might be too weak to recharge the battery while running. The other issue could be a bad voltage regulator

...they all have the same number of cycles. If you're NOT seeing the voltage toggle or see no voltage, then look for a wiring issue in the hinge area. That's the most common place for wire ...

...2010 1.2 Chevrolet B12d1. It died on high speed. OBD results 1. EGR , 2.Thermostat and 3. System voltage low. EGR - removed cleaned even though not clogged and re-installed. Thermostat replaced. ...