...set set timing on a 2.4L engine That is a dual overhead cam engine. On the oil pump housing there is an arrow cast into the housing. Line the arrow on the crank pulley up with the arrow on the oil ...
Question about 1994 Intrepid
...set, a new fuel pump and filter, a new timing belt and waterpump. Was in the shop (dodge dealer) several times and they claim they cant find the problem. PLEASE HELP !!! you need a crank sensor ...
Question about 1986 Ram 50
...timing marks to set the crankshaft to top dead center for a timing belt replacement. I just need a diagram to show me where the timing marks are located, where should the camshaft pulley mark be ...
...Set the timing belt tension. Install the timing belt covers. Install the right engine mount. Remove the floor jack and engine block from underneath the engine. Install the crankshaft damper. Install ...
...set the timing on a 1950 dodge flathead 6 Since I'm not sure how much info you have, here's what I have in my Chilton manual. The firing order is 1-5-3-6-2-4. Your timing marks should be on ...
Question about 1996 Avenger
...Engine light flashes, multi cylinder misfire 0300, then will set code 0152 or 0132. Maybe once in 1000 miles. Try changing the coolant temp sensor, it determines when the ECU shifts from open loop ...
Question about 1996 Avenger
engine is on top dead center. After setting timing properly marks are off within 5 minutes of running. ????? If the engine wont run then it might be an issue. The engine most likely has CVVT (variable
Question about 1996 Avenger
...set timing marks without tearing engine apart again? I assume you're talking about the 2.7L V6. As you're probably aware (having had it apart before), the timing is properly set by aligning the ...
...set timing on 2006 dodge charger 2.7 To set the timing on a 2006 Dodge Charger with a 2.7-liter engine, you will need to perform the following steps: Locate the crankshaft pulley and the timing mark ...
...set. The check engine light is off and I have gone through the drive cycle several times. Make sure it has the correct thermostat temperature, 3/4 tank of fuel. After it reaches operating temp, drive ...
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions