Questions & Answers for: GMC Sierra how to remove tailgate

Question about 1995 Sierra

1 Answer

tailgate How do you remove a tailgate Open tailgate, remove straps or bars on each side. Lift passanger side corner up and out, then you can pull the rest out no problem.

Ad

...rest is pretty obvious. lower the tailgate and remove the screws from the one piece housing,rotate the bulb from its holder about 1/4 turn and remove bulb and change it.hope to help let me know ...

Ad

Question about 2005 Sierra

1 Answer

tailgate on my 2005 GMC Sierra will not unlatch. The handle works and pulls the control bar, but the latch will not release. Sounds like you have a bar disconnected inside the hatch. You may also need

...tailgate. To locate these, remove the three bolts holding in the latch assembly and inspect the clips attached to the two control rods that will latch/release your tailgate. I have found spraying ...

REMOVE THE REAR LIGHT COVERS? lower the tailgate,and you will see two torx screws that hold it in place,when you remove them swing the lense assemble outward to unhook two plastic guides that hold the

...tailgate remove two screws on side of light t15 torx or phillips remove light. middle bulb is signal.To remove bulb push release tang and turn left to remove. Good time to change all bulbs. Same on ...

...tailgate will not open because the latch on the passanger side will not fully retract when I pull the handle. I can visually see that when the handle is pulled .... the draw rod to the right is not ...

...connected with a snap over plastic clip carefully move those off the rods and now the rods can be removed. If it is the handle you are replacing then unbolt from the backside and change. If it is ...

Question about 1990 Sierra

1 Answer

...tailgate. Remove the lamp assembly retaining screws. Pull the lamp assembly from the truck and disconnect the wiring. Remove the bulb holder fasteners. Remove the bulb(s) from the lamp. Install the ...

my tailgate on my truck wont let down Open up the tailgate by removing the screws on the inside of the door T15 or T20 torx bit is required. Disconnect the latch mechanism by unsnapping the plastic ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 GMC Sierra
1998 GMC Sierra

987 Questions

1997 GMC Sierra
1997 GMC Sierra

847 Questions

2000 GMC Sierra
2000 GMC Sierra

676 Questions

1999 GMC Sierra
1999 GMC Sierra

601 Questions

1994 GMC Sierra
1994 GMC Sierra

604 Questions

Manuals & User Guides

Loading...