20 Most Recent 1997 GMC Sierra Questions & Answers

your question is realy garbled but I think you are asking about the timing of the cam and the crank sensors usually you have to have them both replaced at same time which means you can see the NO1 position on the cam and the position of the crank and thats with the cover off but I found out from another friend that if you go onto YouTube and request How To set timing on the Cam shaft and Crank shaft sensors you will get a video. MAKE SURE YOU SPELL IT ALL RIGHT OTHERWISE YOU WILL NOT FIND IT. Sorry about the Caps but wanted your attention use my spelling. Good Luck

1997 GMC Sierra | Answered on Nov 14, 2019

The door panel is held onto the door with clips but first you need to remove the screws from the grab handle on the door panel. then pop the bezel off around the inside door handle. very carefully!!! then using a clip tool pry off the peice that covers the rear view mirror nuts and pry gently all the way around the door panel until its loose then lift it up slightly to unseat the window channel strip off the door, then unhook your wires. As for the window roll it up, tape it to the door then line up the 2 10mm bolts that clamp it to the regulator with the provided holes in the door, loosen 'em up roll the regulator down and remove the window. Have fun guys!!!

1997 GMC Sierra | Answered on Sep 29, 2018

more likely need to replace cluster, known problem, remove it take to your local napa they can send it in for repair.

1997 GMC Sierra | Answered on Feb 02, 2018

It helps to know how it works ! The fuel level sending unit is a input to the VCM - engine computer . The VCM needs this info so it can do evap. emission leak detection testing ! The VCM sends this info. to the instrument cluster via the class 2 serial data network .
U.S. Federal regulations require that all automobile manufacturers establish a common communications system. This vehicle utilizes the Class 2 communications system. Each bit of information can have one of two lengths, long or short. This allows the vehicle wiring to be reduced by the transmission and reception of the multiple signals over a single wire. The messages which are carried on Class 2 data streams are also prioritized. In other words, if two messages attempt to establish communications on the data line at the same time, only the message with the higher priority will continue. The device with the lower priority message must wait. The most significant result of this regulation is that the regulation provides the scan tool manufacturers with the capability of accessing the data from any make or model vehicle sold in the United States.
Hooking up a factory tech 2 scan tool to view sensor data inputs to an from the VCM an checking for DTC'S - diagnostic trouble code's is the proper way to diagnose .
DTC P0462 Fuel Level Sensor Circuit Low Voltage
DTC P0463 Fuel Level Sensor Circuit High Voltage

The Fuel Level sensor is an important input to the VCM for the Enhanced Evaporative System Diagnostic. The VCM needs the fuel level information in order to know the volume of fuel in the tank. The fuel level affects the rate of change in the air pressure in the EVAP system. Several of the Enhanced Evaporative System Diagnostic sub-test are dependent upon the correct fuel level information. The diagnostic will not run when the tank is greater than 85% or less than 15% full. (This sensor signal disables the misfire when the fuel levels are less than 15%). This DTC is a type D DTC.

Action Taken When the DTC Sets
• The control module stores the DTC in history after the first failure but will not illuminate the malfunction indicator lamp (MIL).

Your best bet , take it to a qualified repair shop.

1997 GMC Sierra | Answered on Jan 08, 2018

Check for vacuum leaks the rubber or plastic line may have a hole. Distributor timming maybe off also. Cracked cap or worn comtacts in the cap. Coolant temp sensor affects fuel trim aka rich lean conditions

1997 GMC Sierra | Answered on Oct 31, 2017

what I think is your calipers are used to being in the outer extension of the piston stroke. when that happens sometimes moisture can set in and oxidize the piston surface, now when you shove the piston back into the caliper to clear the new pad it will stick to the walls of the bore and put to much pressure on the pads then come heat and warp. Next time you replace it buy the preloaded caliper and pad combo an bob your uncle, which mean you should be good. hope this helped.

1997 GMC Sierra | Answered on Oct 21, 2017

tranny bad

1997 GMC Sierra | Answered on Oct 17, 2017

replace the fuel pump relay.

1997 GMC Sierra | Answered on Sep 28, 2017

Chang the fuel filter.

1997 GMC Sierra | Answered on Sep 22, 2017

sealed beams on this one or four headlights? Also, with or without daytime running lights?

1997 GMC Sierra | Answered on Aug 13, 2017

Return it ASAP to whomever did the trans work. You paid for it,

1997 GMC Sierra | Answered on Aug 02, 2017

Yes it will bolt up, but the electronic control will be different.

1997 GMC Sierra | Answered on Jul 01, 2017

When you turn the ignition to start, do you hear the starter turning and the solenoid engaging the flywheel ? test your starter by jumping it and see if the engine turns over. If this works, then you might consider in checking fuel pressure. Do you have any codes in your ECM ?

1997 GMC Sierra | Answered on Jun 24, 2017

I don't think you could trust that either. Sounds like the sending unit in the tank is messed up, so it may never read correctly. By now, you must know the approximate miles per gallon it gets, so until you get the gauge fixed, you should go by the number of miles you go to know when it needs gassing up. Just as a ballpark figure, a '97 Sierra, city driving, maybe 15-17 mpg? I really don't know, you could google it I'm sure.

1997 GMC Sierra | Answered on Jun 09, 2017

does it stay at floor if tou pump it?

1997 GMC Sierra | Answered on Jun 06, 2017

Not finding what you are looking for?
1997 GMC Sierra Logo

1,281 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 GMC Sierra
1998 GMC Sierra

971 Questions

2000 GMC Sierra
2000 GMC Sierra

661 Questions

1999 GMC Sierra
1999 GMC Sierra

584 Questions

1994 GMC Sierra
1994 GMC Sierra

587 Questions

1996 GMC Sierra
1996 GMC Sierra

437 Questions

Top GMC Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sierra GMC

  • Sierra GMC

Most Popular Question

fix 97 gmc 1 2 ton 350 vortec runs

  • Cars & Trucks